I want to increase the HP of my focus by getting a new exhaust, cold air intake, new spark plugs with 2 electrodes, and then a tune to top it off. I’m curious on how much HP I’ll have after everything is finished. Stock supposedly has 160 and I know it won’t be a huge jump and I won’t get actual...

Hello everyone! I have a 2016 Ford Focus SE and I recently upgraded the head unit using the iDatalink Maestro kit along with a Pioneer headunit (with CarPlay). I have a couple of issues now, the backup camera works but the quality is awful, the rear parking sensors does not work and sometimes...

Hi all, I'm new to this community and just purchased a 2014 Focus Titanium sedan. I'm going to have this car for a long while considering it's very low mileage and relatively excellent condition. I was wondering if anyone had any suggestions for some starter upgrades? I'd like to know if there's...

I’m trying to figure out what should be my first upgrade is a 06 automatic zx4 29,000 miles anything will help

This is my journey on updating my IPC to Mk3.5 with the digital speedometer. DISCLAIMER: THIS HAS ONLY BEEN TESTED FOR 2012-2014 FORD FOCUS WITH SYNC V1 WITHOUT TOUCH. ANY OTHER VEHICLE OTYER THAN MK3 FOCUS I CANNOT PROMISE IT WILL WORK. MY RESULTS MAY VARY FROM OTHERS, FOCCCUS IS A...

Hey guys I’ve upgraded from mk2 to 2017 mk3 1.5 EcoBoost, I’ve few questions and can anyone recommend a place for right hand drive interior carbon fiber trims, I’ve found site awdmods witch have a lot of options, but kind of of certain If Rs and St parts will fit also any recommendations on...

SOLD Item Description: This is a front SVT upgrade kit consists of: 1. SVT Caliper (reman NAPA Calipers) 2. SVT Front Drilled and Slotted Rotors - 11.81 in (from R1 Concepts eLine Series) 3. R1 Concepts Ceramic Pads This kit is in very good used condition, less than 3K miles on it...

Thanks for checking this out, I recently got an '01 ford focus zx3, and am seeing if I can find a couple things for it. -A Cold Air Intake -Any engine upgrades-cams, intake, cylinder head assembly. I suppose if you have a turbo kit i'd check it out, but currently wouldn't have all the moneys...

Hey guys. I'd really like to find upgraded 32mm front axle nuts for my Zetec axles. I'm not a fan of the multi ply steel nuts and their issues with loosening. Has anyone found an upgrade replacement? Idealy a one piece billet steel nut. Let me know, thanks!!