Focus Fanatics Forum banner
1-5 of 8 Results
  1. Engine & Transmission Swap
    I've pulled my tranny out to change the clutch and slave cylinder. I'm just having a hard time getting the tranny back in place. Any tips for me? I got a transmission jack but there isn't much space for me to work with when I try to lift it in place. I tried benching it into place and got pretty...
  2. MK1 Focus
    First post! I've been here reading posts for about a year now though. After 165K miles on the original clutch, its time to replace it. Not slipping yet, but I had some down time, thought I'd be proactive. 2007 Focus ST 2.3L MTX-75 transmission After reading a couple posts here and...
  3. MK3 Focus
    Hi, has anyone here swapped a single mass flywheel into a north american MK3 focus? If so what part did you use? Would a clutch/flywheel kit meant for a MK1/MK2 US focus work on the MK3 as well since it is the same MTX-75 manual gearbox? thanks
  4. MK1 Focus
    I JUST bought my car, and I am having noise from my transmission, and want to get it rebuilt for the most part. Looking at getting a bearing/seal kit, but I've run into an issue. All of the kits I find ask if I have an 18.5mm or 20.5mm rear pinion bearing. I have zero clue how to figure out...
  5. SVT Performance (2002-2004)
    So, the trans. is out on the car. Re-cap: 02 svt. 32k on odometer. At the shop and they say it is because the clutch was so fried that it caused damage to the trans. They claim that the clutch had a T.S.B on the fly wheel and that i should have had notice of the T.S.B. In short, needs new...
1-5 of 8 Results