Focus Fanatics Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 12 Results
  1. Engine & Transmission Swap
    Anything that has the same bolt patterns that I could find relatively easily? Not sure what I want to do, just fishing for ideas really, I gotta do something with this car though. I just put a bunch of money into redoing the whole suspension and a new clutch, full stainless exhaust, no rust...
  2. MK1 Body Parts/Interior/Electronics & Acc. '00-'07
    SOLD a. Your Item Description: • I found a set of SAP bumpers with the lights and diffuser on a 2006 ZX4 (but they should fit everything but a wagon). They're light silver and in good condition. I'm not sure what my cost is yet, but if anyone is interested, I can get the parts and make them...
    $1 USD
  3. General Technical Chat
    On cold mornings, the car cranks but takes several minutes to start. Mechanic changed fuel pump to fuel rail. No fuel pressure while cranking. Temperature sensors read correctly. Once it starts, it runs fine for the rest of the day. Mechanic couldn't figure it out. Anyone smarter than my mechanic?
  4. FocusFest Caravan
    Hey, So my girlfriends Focus has started stalling out occasionally when at low RPMs, finally pushed a code, engine too lean and bank 1 sensor 1 too lean... So i pop the hood with it idling and i can hear a vacuum leak but cant find where it is to save my life (her engine is super loud lol)...
  5. Brakes, Suspension & Body Chassis
    (Skip this paragraph to get straight to the technical error) I just created my account because I'm seriously struggling with this issue. I'm 18 Y/O, and recently bought my first car, which was a 2006 ZX3 SES. It needed some love, it was very dirty on the inside, but was actually in pretty...
  6. 2006 ZX4 SES

    After PlastiDip'd grille
  7. 2006 ZX4 SES

    Stock Surround with new deck
  8. Car Audio, SYNC, MyFord Touch & Electronics
    Hi everyone, So i just picked up a 2006 ZX3 SES to replace my 2003 ZX3 which got rear ended about a month ago on the high way. I pulled my pioneer 6000uB deck out of the car along with the antenna adapter and dash kit but they obviously don't fit. I've found the various dash kit/wire harness...
  9. Brakes, Suspension & Body Chassis
    Well today i put on my Roush Front and Rear Struts and springs and my SVT Rear Sway Bar (had no sway bar previously). It took 8 hrs and had to fabricate 4 pieces (see below). It was a fun job, and really not that hard. Had no real problems and i am liking the results (and can't wait for...
1-9 of 12 Results