Focus Fanatics Ford Focus Forums
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace
My Account
Merchandise Store
Active Topics
Discussion Forums
Technical Forums
Regional Forums
About Us
Contact Information
Fanatics Online: 2,136
Guest Online: 6596

Threads: 301,797
Posts: 5,274,325
Members: 111,579

2/24/2014 12:32:23 PM
How-To : ST170 Headlights Installation Lil Pzev
Warning: Neither Focus Fanatics nor its Members may be held responsible for the outcome of performing such a modification to ones car(Ford Focus). Such acts are performed at ones own risk, and sole responsibility must be assumed. This may include, but not limited to, the voiding of Ford vehicles factory warranty.

Always put safety first; using jackstands, eye protection, and all other required safety measures. It is also recommended to have supervision whenever possible.

Items Needed:
1. Jack/jack stands, optional, but helpful if your car is lowered
2. 6mm Socket
3. 13mm Socket
4. 10mm Socket
5. 10mm Wrench (a couple places are too tight a squeeze for the socket)
6. Wire Strippers (or utility knife, but trust me these are easier!)
7. Flat-head Screwdriver
8. Electrical Tape
9. Soldering gun OR no-crimp/no-solder wire connectors
Install Time: Difficulty Level:
1-3 Hours 6
  Step 1
Assemble your headlights with the bulbs provided. No pics of this, but look at the back of the light and you'll probably understand what needs to be done. I'd never so much as replaced a bulb in my headlight before and I figured it out, so you'll do fine!

Open the hood and locate the 3 plastic bolts holding on your radiator cover... See the 2 over my yellow sticker and one on the far right: (Picture 1)

Remove those with a flat bladed screwdriver, pliers or a tool which can be found at most auto parts stores for removing car fasteners. When you lift off the cover you see this: (Picture 2)
Step 3
Twist the bulb holders behind the turn signals and then remove the 4- 10mm bolts holding on your grille, 2 are down lower. Here's a driver's side pic showing the 2 on that side and the turn sig thing still plugged in: (Picture 3).

Step 4
Now you take off the headlights. There are 4- 10mm bolts holding each one in. One is small and rubber, located at the corner of each light, towards the grille area, this can be twisted off with your fingers. Another is almost in the middle on top of the light and a third is at the upper corner and is bolted in sideways: (Pictures 4&5)

This is where the rubber bolt was... it won't be used with the new lights, it's in the dark region, sorry! =P It's not that large black knob thing up top, I'm not sure what that is.
Step 5
The fourth bolt is located below your headlight, and here's where you might need a little "boost". My car's not lowered but for convenience I hopped it up on a hydraulic jack (no stands, etc)... I've heard this is bad safety technique so Do So At Your Own Risk. The bolt is also 10mm and located a bit north of the sidemarker, under a little metal "roof". It heads from the fender side into the bottom of the headlight.

Beware, there is another 10mm bolt that looks directly down at you and that's Not it! This bolt is a sideways one and a bit cramped, if you want, use the wrench here. Also, you can look at the bottom of the new headlight to get an idea of where to look, that helped me. Left arrow shows the sidemarker bulb holder (a little below it you can see Wrong Bolt, its blue and I think helps hold on the bumper?), the right arrow indicates the direction and placement of the bolt (this is my driver side from down below, see the blue metal "roof" I was talking about?): (Picture 6)
Step 6
Once your headlights are freed, unplug the wiring harness to them. You will see a triad of wires and they are 4, 7, 6, from the top then left-right, these numbers are also stamped on the black plastic: (Picture 7)
  Step 7
Cut the wires from each headlight harness with scissors/wire snips, but only once you know which are what color. Mine: 4= black (ground), 6= green/orange (high beams) and 7= green/white (low beams). Do the same with your turn signal harnesses, but note that if you snip the wires close to the harness you may not be able to use your stock grille with signals again. Each of my sides were different but here's what I had, left to right have the same functions. Driver: Black (ground), Orange w/ blue stripe (parking/city lights), Blue w/ orange stripe (blinker). Passenger: Black, Green/orange, Blue.

You have 2 options for turn signals, either way you won't use the black wires. If you want to have no orange when parking lights are on, only work as the blinker then also leave out the middle wire on each side. If you want the orange in the headlight whenever lights are on, and flash when blinker goes on, splice the middle and 3rd (non-black) wire.

Whichever wires you don't use for the turn signals, cut so the copper isn't exposed, wrap in electrical tape and tuck them back into the plastic tubing. (Later on, tuck the used wires in the signals and headlights also into their respective tubings and wrap a bit of tape around the plastic to keep it shut and clean-looking.)

Step 8
Turn your attention to the harness kit you bought, you will need 8 yellow wires with clips on them and 2 black VW adaptors. Notice the numbers on the holder, the side which the snap-holding tab is on and the little purple plastic piece you see from the side. Now put wires into slots 1, 2, 3 and 6. You want to put them in from the bigger side (round, not + shaped holes), clip end first. If they go in nice and straight you hear/feel a light snapping which indicates the wire is secured in place. Here's what you don't want: (Picture 8)

You see too much of the wire head here, they were put in backwards, by putting the cut ends in through the + holes. Here's the right way: (Picture 9)

See how you can just see the metal clip part shining there? Good. Now push the adaptor onto its place on the headlight, but NOT all the way yet, just enough so you think they made contact. Go turn your key to Accessory and CHECK all your lights' functions!

Now take something (a small flathead works) and push on the purple thing in the VW adaptor from the side opening. It will slide over and lock your yellow wires in place. Be sure you have them in the right slots before doing so (if the check worked, you're cool) because unlocking it again is annoying and requires prodding with a small screwdriver and some swearing. Then plug the adaptors into the place in back of your headlights until you hear the snap of the plastic clip catching on.
  Step 9
Now for which wire goes where. Starting from the headlight: Connect VW (yellow) wire 1 to original wire 6 (green/orange- high beam). Then VW wire 2 to Ford wire 7 (green/white- low beam). Lastly hook up your Ground by connecting headlight wire 4 (black) to VW wire 6.

If you only want orange for your blinker, now you only have one wire left! If not, you have 2 wires spliced into one, so close enough! Take that wire(s) and connect it with VW wire 3 so you have turn signals. Now all 4 VW wires are attached to something that runs into your Focus.

Note: I didn't shorten any of the yellow wires, but I did add about 3" or so to VW wire 3 since I couldn't put my new headlights into position without an extension since the turn sig wires are quite short. My wiring harness came with 10 yellow wires (only used eight) so I stripped one into two pieces, both ends of each with exposed wire, and used my last 2 red connectors (Pack of 10).
  Step 10
You are effectively DONE! Now, position the lights back into their spaces.

*Duratec owners (and maybe others?), my passenger one was resistant because I had some hoses that pressed against the back of the VW adaptor. Push them out of the way with one hand as you settle the light in, it fits with some wiggling (also, verbally insult the hoses' placement, I found that helped too). I believe these are A/C wires, so maybe if you don't have A/C you're fine.*
  Step 11
Put back on your stock grille, or the signal-less Euro model that you bought to go with these headlights, and replace your radiator cover. End note: Have a good memory or organize your bolts so you know which goes back where. I kept my headlight bolts separate from the rest since I thought they were most important. *If you have the Duratec, you'll have a lot more bolts lying around from pulling out your intake- don't forget to put that back, or an aftermarket one!*

Lastly, step back and look at the result of all your hard work!!! Feel free to PM me or post any questions you may have about the install!

Personal Note: Although he'll never read this, I need to leave a HUGE thank you to my Dad who came over on his Day Off to help me when I realized the wiring was wrong and I didn't know why or have the tools to figure out which was right. Without him I'd probably still be experimenting with each terminal on the back of the headlights!
Ford Focus Wallpapers
Ford Focus Gallery
Member Login
User Name:
Forgot your Password?
Create Account
Active Ford Focus Forum Topics
2008-2011 Picture Th... (7802)
Front End Noise (3)
Finished it last wee... (8)
Did the lunchbox del... (4)
What did you do to y... (2454)
08 Focus needed at S... (0)
tire rotation (5)
What is the most svt... (202)
$50.00 IF design is... (17)
Official '03 SVT Own... (267)
Ford Focus Tire & Wheels
AEM Intakes
Ford Focus Discussion Forums
Ford Focus & General Car Chat
Ford Focus Technical Chat
Ford Focus Discussions
Ford Focus Performance Mods
General Chat Lounge
Ford Focus Social Groups
Regional Forums
Exclusive Vendor Discussions
Vendor Group Buys & Specials
Buy - Sell - Trade Ford Focus Parts & Accessories
Racing, Rally & Autocross
Shows, Meetings & Events
Fanatics Ford Focus Owner's Club
Brakes, Suspension & Chassis
Wheels & Tires
Ford Focus Car Audio & Electronics
Nissan IDx Forum

Copyright 2002-2014 All Rights Reserved : Terms of Use : Privacy Policy : Affiliates : Advertise Information : Site Map

Focus Fanatics - Online Ford Focus Community for the UK, North & South America, Europe, Asia, Australia, and Africa regions. We are the Internet's Largest Member based Ford Focus Forum. We offer one of the largest Ford Focus-related news and events information. We also offer free Ford Focus classifieds, Ford Focus gallery, regional Ford Focus forums, and Ford Focus performance forum discussions. Our mission is to provide Ford Focus owners an information outlet, a means to communicate with other Ford Focus owners, ask questions, and chat among forums. We also have a Ford Fiesta Forum, Ford Fiesta ST Forum and Ford Fusion Forum for other Ford Focus owners outside the Ford Focus community.