Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Testing 8S4Z-9P471-A Tumbler Rotary Position Sensor on 2.0L
View Single Post
Old 04-18-2019, 07:49 AM   #10
[email protected]
Focus Jr. Enthusiast
 
Join Date: Jan 2017
Fan#: 338626
Location: Pleasant Prairie, WI
What I Drive: 2010 Red Focus SEL

Posts: 33
Points 133, Level 2
Points: 133, Level: 2 Points: 133, Level: 2 Points: 133, Level: 2
Level Up 66% Completed
Level up: 66% Level up: 66% Level up: 66%
Forum Activity 72%
Activity: 72% Activity: 72% Activity: 72%
FF Reputation: 1 mscotese@aol.com Good Standing Member
Buy-Sell-Trade Rating: (0)
Many thanks for the additional info. My 2 codes are P0642 sensor reference voltage “A” circuit is too low and P2004 intake manifold runner stuck open.

Can you tell me if on a 2010 Focus if the Flaps are Open or Closed when there is no vacuum in the actuator and the little white ball joint is up and easily visible while looking at the top of the engine? I assume that this is the Open position?

Thanks again, Mike

Last edited by [email protected]; 04-18-2019 at 07:57 AM.
mscotese@aol.com is offline  
    Reply With Quote