Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum

Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum (
-   ZETEC Performance (2000-2004) (
-   -   VF engineering rear motor mount install (

drewzx3 07-27-2004 01:26 PM

VF engineering rear motor mount install
Can anyone explains how to install it? I bought it used without any instructions.

whiteboyslo 07-27-2004 01:46 PM

1) jack the car up (or put it on ramps)

2) crawl under and find the old mount

3) undo the bolts that hold the mount in the bracket at both ends. sorry, i don't remember the size

4) pull out the old mount. it may be necessary to use a pry bar or something for this because there's not a LOT of room to play with. if necessary, you may find removing reomving the front bracket from the engine makes this easier

5) put everything back in in reverse order. i don't know the torque specs off hand, though. a focus repair manual would probably have them. be patient with everything bc it IS a tight fit! you also lose the play built into the original mount, so that makes it even more difficult (of course, that's why you're replacing the mount in the first place). it took some experimenting to figure out the order to put stuff back in, but i think i put the back end on first (the one that mounts to the x-member) and THEN i put in the end that mounts to the engine. probably doesn't matter though.

the job isn't that hard to understand once you get under there. it's just doing it that is the PITA!


drewzx3 07-27-2004 04:33 PM

Does the cupped part of the mount go up or down?

cen 07-27-2004 07:20 PM

cupped part goes down, and also support your transmission with a jack just to be safe.... you are removing one of the mounts that hold it in place remember....

All times are GMT -5. The time now is 11:13 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.