- - 2003 SPI problem
01-10-2013 04:17 PM
2003 SPI problem
OK so my SPI blew up as usual. I found a rebuilt 2.0 SPI in a 2001. Heard it run. Installed it into my 2003. Engine cranks but will not start. I can hear the fuel pump start up. Everything hooked up. Fuel pu,p inertia switch not tripped. Any thoughts? Only thing i did was had to wire directly the crank position sensor without the connector because it broke during removal/installation. Thoughts?
01-10-2013 07:54 PM
Did you hook up the brown yellow ground on the right side of battery?
01-10-2013 08:15 PM
Is it hooked to the negative terminal? Or something else? Not at the car right now but I dont remember a ground strap over there.....
01-10-2013 08:17 PM
would the crank position sensor wiring, if it isnt perfect, cause a no-start condition? Wondering if I need to re-visit that...I used one of those dual female middle crimp jobs on each wire.......to connect them.
01-10-2013 08:18 PM
how can I check if i am getting fuel up to the rail? There is no schrader valve up there.....
01-15-2013 10:58 AM
any more help guys? Does this sound like its a crank position sensor issue? Turns over freely just no start....fuel pump def pressurizing....