I am just about to finish pulling the engine block (2L SOHC) out of my 2001 SE. Just wanted to know if the fly wheel-torque converter bolts are undone thru the hole left after starter is taken out.I can see bolts thru starter hole but not sure how to get at them as the are slightly lower than the hole. Any advice would be appreciated.FYI head is already off the block. Was also wondering if cylinder compression ratings of 160-166 are good or bad ratings.
There is an access plate you must remove at the bottom of the block where it meets the transmission.It is held on with two small bolts.It will be hiding behind the cat. converter pipe if you have not taken that off yet.
|All times are GMT -5. The time now is 07:03 PM.|
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.