HOW-TO: SVT IMRC DSI Intake Manifold Upgrade FOR ZETEC!!!! - Page 8 - Ford Focus Forum, Ford Focus ST Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus First Generation > ZETEC Performance (2000-2004)

ZETEC Performance (2000-2004) The place to chat about any 2.0L Zetec engine performance, tuning and exhaust related upgrades.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Reply
 
Thread Tools Display Modes
Old 02-07-2006, 12:03 AM   #71
focituner
Focus Addict
 
focituner's Avatar
 
Join Date: Sep 2003
Fan#: 628
Location: Philadelphia, PA
What I Drive: 2004 ZX3 2.3 (DKG1)

Posts: 881
FF Reputation: 1 focituner Good Standing Member
Buy-Sell-Trade Rating: (5)
The new TB was part of the package deal, It is SWEET. Great response improvement.
focituner is offline  
    Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 03-03-2006, 09:45 PM   #72
focituner
Focus Addict
 
focituner's Avatar
 
Join Date: Sep 2003
Fan#: 628
Location: Philadelphia, PA
What I Drive: 2004 ZX3 2.3 (DKG1)

Posts: 881
FF Reputation: 1 focituner Good Standing Member
Buy-Sell-Trade Rating: (5)
I am working on a Tune with Hypnotic and will post up Dyno numbers in a few weeks.
focituner is offline  
    Reply With Quote Quick reply to this message
Old 03-03-2006, 09:52 PM   #73
SVT_BMXer
Focus Fanatic
 
SVT_BMXer's Avatar
 
Join Date: Aug 2004
Fan#: 11226
Location: Columbus, OH
What I Drive: 1991 BMW 318is

Posts: 9,084
FF Reputation: 20 SVT_BMXer Great Standing Member
Buy-Sell-Trade Rating: (17)
awesome install and great write up!!!
__________________
02 Jackson Racing supercharged SVT
SOLD

Current:1991 BMW 318is: Bilstein sports, H&R springs, TMS chip, UUC short shifter, dyna-max muffler
SVT_BMXer is offline  
    Reply With Quote Quick reply to this message
Old 04-05-2006, 04:05 PM   #74
sc0tty8
Focus Enthusiast
 
Join Date: Sep 2005
Fan#: 27536
Location: Litchfield MN
What I Drive: 2k3 Pitch Black ZX3

Posts: 104
FF Reputation: 1 sc0tty8 Good Standing Member
Buy-Sell-Trade Rating: (0)
Hey foci-tuner, did you get any update from dan reguarding the 12volt vs 6 volt yet?

I am getting ready to finally do my swap now that its warm out and the snow is gone.
sc0tty8 is offline  
    Reply With Quote Quick reply to this message
Old 04-05-2006, 08:59 PM   #75
focituner
Focus Addict
 
focituner's Avatar
 
Join Date: Sep 2003
Fan#: 628
Location: Philadelphia, PA
What I Drive: 2004 ZX3 2.3 (DKG1)

Posts: 881
FF Reputation: 1 focituner Good Standing Member
Buy-Sell-Trade Rating: (5)
no, I haven't but i am still running with no problem.
focituner is offline  
    Reply With Quote Quick reply to this message
Old 04-22-2006, 05:14 PM   #76
sc0tty8
Focus Enthusiast
 
Join Date: Sep 2005
Fan#: 27536
Location: Litchfield MN
What I Drive: 2k3 Pitch Black ZX3

Posts: 104
FF Reputation: 1 sc0tty8 Good Standing Member
Buy-Sell-Trade Rating: (0)
Well, I started the swap on my slocus.

You will for sure want to get the AC vac lines, and, the master cylinder vac line.

For the fuel rail, I bought some vac line from the parts store and snaked it under my manifold.

You will want to get the SVT alt bracket, I got pics of them side-by side, the svt braket rolls the alt towards the fire wall and lower....

You can get the manifold in there w/o splitting it apart, I did it.

You will also want to get the pig tail for the TPS, one of the few items holding me back...my TPS from the stock tb doesnt bolt up like the svt one, the svt one points up, my stocker points down, differant sized connectors, does not mate up to the svt TB like it does to the stock in terms of the position of the blade in the TB...

I am about to install the IMRC and run the wire for that, I am trying to figure out how to mount it w/o having to remove my headlight but will prob remove the head light. I have not wired up my window switch as of yet.

The wire that goes down to the sensor on the back of the motor by the oil filter, I am guessing oil pressure switch, needed to be extended 2" for me.

So far, its not all bad...yet...
sc0tty8 is offline  
    Reply With Quote Quick reply to this message
Old 04-23-2006, 10:36 AM   #77
deckzx5
Focus Jr. Enthusiast
 
Join Date: Apr 2004
Fan#: 6134
Location: Illinois
What I Drive: ZX5

Posts: 33
FF Reputation: 1 deckzx5 Good Standing Member
Buy-Sell-Trade Rating: (0)
I have had this manifold on my car for a while now and I do not have the pig tail connector that ties to the IMRC. So I do no know which wire is the Green/White, Black/White 1st or 2nd, or the Blue/White on the IMRC. Does anyone have one of these plugs they can take a picture of and post it? If so, it would help me out so that I see where these wires are on the connector? Thanks
deckzx5 is offline  
    Reply With Quote Quick reply to this message
Old 04-23-2006, 11:01 AM   #78
sc0tty8
Focus Enthusiast
 
Join Date: Sep 2005
Fan#: 27536
Location: Litchfield MN
What I Drive: 2k3 Pitch Black ZX3

Posts: 104
FF Reputation: 1 sc0tty8 Good Standing Member
Buy-Sell-Trade Rating: (0)
I have the wiring diagram on paper, you will want the pig tail so I can tel you what pin is what, the connector is numbered....
sc0tty8 is offline  
    Reply With Quote Quick reply to this message
Old 04-24-2006, 10:08 AM   #79
deckzx5
Focus Jr. Enthusiast
 
Join Date: Apr 2004
Fan#: 6134
Location: Illinois
What I Drive: ZX5

Posts: 33
FF Reputation: 1 deckzx5 Good Standing Member
Buy-Sell-Trade Rating: (0)
I will purchase a pigtail from Ford this week. Hopefully it will have the numbers.
deckzx5 is offline  
    Reply With Quote Quick reply to this message
Old 04-24-2006, 01:36 PM   #80
sc0tty8
Focus Enthusiast
 
Join Date: Sep 2005
Fan#: 27536
Location: Litchfield MN
What I Drive: 2k3 Pitch Black ZX3

Posts: 104
FF Reputation: 1 sc0tty8 Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally posted by deckzx5
I will purchase a pigtail from Ford this week. Hopefully it will have the numbers.
It will if you get it from tousley, just tell steve you want the pin out/wuire diagram for the imrc.
sc0tty8 is offline  
    Reply With Quote Quick reply to this message
Reply

Bookmarks & Social Networks

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:35 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Cadillac ATS-V, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.