Tuning Solution (Injected Engineering) - Page 140 - Ford Focus Forum, Ford Focus ST Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus Third Generation > DURATEC Ti-VCT Performance (2012-Current)

DURATEC Ti-VCT Performance (2012-Current) The place to chat about any Duratec 2.0L Ti-VCT engine performance, tuning and exhaust related upgrades.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Reply
 
Thread Tools Display Modes
Old 06-19-2013, 04:06 PM   #1391
Aric@Injected
FF Affiliate
 
Aric@Injected's Avatar
 
Join Date: Apr 2013
Fan#: 113187
Location: Kennesaw, GA
What I Drive: '13 Sonic Blue test pig

Posts: 509
FF Reputation: 10 Aric@Injected Great Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by darkangelism View Post
DCTs should have two .H32 numbers right?
You would be correct. I should have added those

If you have a DCT make sure you pull the TCM info out.

Examples of TCM Software Part numbers: (Notice the middle numbers are different than the PCM software part numbers)
BV6P-7J104-DB
BV6P-7J104-DA
BV6P-7J104-AL
BV6P-7J104-AK

Examples of TCM stratagies:
TQZL1C5.H32
TQZK7T6.H32
TQZK4C4.H32
TQZK3C3.H32


And TCM part numbers:
BV6P-7Z369-DA
BV6P-7Z369-AL
BV6P-7Z369-AK
BV6P-7Z369-AJ


again... I can cross any of these numbers over for your vehicles.

Please make sure your write down the correct numbers. I have a few come in as "Z" and should have been a "2".
Aric@Injected is offline  
    Reply With Quote
Sponsored Links
Advertisement
 
Old 06-19-2013, 04:19 PM   #1392
Aric@Injected
FF Affiliate
 
Aric@Injected's Avatar
 
Join Date: Apr 2013
Fan#: 113187
Location: Kennesaw, GA
What I Drive: '13 Sonic Blue test pig

Posts: 509
FF Reputation: 10 Aric@Injected Great Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by waynec92 View Post
alright so it's been forever since i've been on this thread, does anybody have copies of the dyno sheets from this tuner from injected? i'm interested in the 87 tune and 93 tune, i have an injen intake
This is from our test car 2013 5 Door DCT. 100% from the factory. The blue lines are factory calibration (speed limiter raised and rev limiter raised) with 87oct fuel. The red is with 93oct fuel and our cal file.

ALL runs were made with the hood down, starting run ECT temps ~200*f, 4th gear, and completely stock hardware on the vehicle.
Attached Thumbnails
Click image for larger version

Name:	stock vs 93tune.jpg
Views:	52
Size:	98.7 KB
ID:	18430  

Aric@Injected is offline  
    Reply With Quote
Old 06-19-2013, 04:47 PM   #1393
novus
Focus Fanatic
 
novus's Avatar
 
Join Date: Dec 2012
Fan#: 107022
Location: Scott AFB, IL
What I Drive: '12 Tuxedo Black Focus SEL

Posts: 1,544
FF Reputation: 5 novus Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by Aric@Injected View Post
This is from our test car. 100% from the factory. The blue lines are factory calibration with 87oct fuel. The red is with 93oct fuel and our cal file.

ALL runs were made with the hood down, starting run ECT temps ~200*f, and completely stock hardware on the vehicle.
Forgot to mention the limiter on the graph! Just so people don't get their panties in a bunch about "consistency"
__________________
Hatch Nation #118
novus is offline  
    Reply With Quote
Old 06-19-2013, 04:58 PM   #1394
Aric@Injected
FF Affiliate
 
Aric@Injected's Avatar
 
Join Date: Apr 2013
Fan#: 113187
Location: Kennesaw, GA
What I Drive: '13 Sonic Blue test pig

Posts: 509
FF Reputation: 10 Aric@Injected Great Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by novus View Post
Forgot to mention the limiter on the graph! Just so people don't get their panties in a bunch about "consistency"
You are correct. I fixed the above post. I'm not very good at forum talk. This is the most I have ever posted in a forum in 15 years! lol

I push the keyboard to make power not talk
Aric@Injected is offline  
    Reply With Quote
Old 06-19-2013, 05:00 PM   #1395
dyn085
That Guy
 
dyn085's Avatar
 
Join Date: Apr 2012
Fan#: 98047
Location: Fayetteville, NC
What I Drive: 2014 FiST/FoST

Posts: 12,134
FF Reputation: 49 dyn085 Great Standing Member
Buy-Sell-Trade Rating: (5)
Quote:
Originally Posted by novus View Post
Forgot to mention the limiter on the graph! Just so people don't get their panties in a bunch about "consistency"
There's not really a need due to the fact that the maximum hp is occurring before redline.
__________________

FocusFest 2013: Best of Show
Gateway FFW: Show Class Outstanding
September '13 ROTM
2014 FiST-
dyn085 is offline  
    Reply With Quote
Old 06-19-2013, 05:04 PM   #1396
Aric@Injected
FF Affiliate
 
Aric@Injected's Avatar
 
Join Date: Apr 2013
Fan#: 113187
Location: Kennesaw, GA
What I Drive: '13 Sonic Blue test pig

Posts: 509
FF Reputation: 10 Aric@Injected Great Standing Member
Buy-Sell-Trade Rating: (0)
Its all good... wait till we post all the data for our CAI (a real cold air intake), our throttle body, our header, and exhaust system...
Aric@Injected is offline  
    Reply With Quote
Old 06-19-2013, 05:06 PM   #1397
theshrewz
Focus Enthusiast
 
Join Date: Aug 2012
Fan#: 103228
Location: Westminster, CA
What I Drive: 2012 Silver Se Focus

Posts: 273
FF Reputation: 2 theshrewz Good Standing Member
Buy-Sell-Trade Rating: (0)
Damn I really Need a Tune my Se is beggin for it with my Steeda CAI, F2 header and Full 2.5 exhaust. After this I dunno what else is gonna be next, 200 WHP is my end goal.
theshrewz is offline  
    Reply With Quote
Old 06-19-2013, 05:14 PM   #1398
darkangelism
Sonic Crew #04
 
darkangelism's Avatar
 
Join Date: May 2011
Fan#: 85425
Location: oklahoma city, OK
What I Drive: 2012 Focus Titanium Hatch

Posts: 7,328
FF Reputation: 9 darkangelism Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by Aric@Injected View Post
Its all good... wait till we post all the data for our CAI (a real cold air intake), our throttle body, our header, and exhaust system...
You just let slip that you have a header and throttle body in development, that is news.


Quote:
Originally Posted by Aric@Injected View Post
You would be correct. I should have added those

If you have a DCT make sure you pull the TCM info out.

Examples of TCM Software Part numbers: (Notice the middle numbers are different than the PCM software part numbers)
BV6P-7J104-DB
BV6P-7J104-DA
BV6P-7J104-AL
BV6P-7J104-AK

Examples of TCM stratagies:
TQZL1C5.H32
TQZK7T6.H32
TQZK4C4.H32
TQZK3C3.H32


And TCM part numbers:
BV6P-7Z369-DA
BV6P-7Z369-AL
BV6P-7Z369-AK
BV6P-7Z369-AJ


again... I can cross any of these numbers over for your vehicles.

Please make sure your write down the correct numbers. I have a few come in as "Z" and should have been a "2".
The H32 numbers look to be 4 letters number letter number so that should help to figure out 2 vs Z
darkangelism is offline  
    Reply With Quote
Old 06-19-2013, 05:29 PM   #1399
Aric@Injected
FF Affiliate
 
Aric@Injected's Avatar
 
Join Date: Apr 2013
Fan#: 113187
Location: Kennesaw, GA
What I Drive: '13 Sonic Blue test pig

Posts: 509
FF Reputation: 10 Aric@Injected Great Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by darkangelism View Post
You just let slip that you have a header and throttle body in development, that is news.




The H32 numbers look to be 4 letters number letter number so that should help to figure out 2 vs Z
Some strategies (the codes that end with a .h32) can end with letters or numbers.

PCM's
HFCK055.H32
HFCK0A5.H32
HFCJ45V.H32
HFCJ35Z.H32



TCM's
TQZM6DB.H32
TQZM4T7.H32
TQZL3T8.H32
TQZL3T6.H32
Aric@Injected is offline  
    Reply With Quote
Old 06-19-2013, 05:30 PM   #1400
Tjrommel
Focus Enthusiast
 
Tjrommel's Avatar
 
Join Date: May 2013
Fan#: 114674
Location: Cincinnati, OH
What I Drive: 2013 Oxford white Sedan 5M

Posts: 294
FF Reputation: 1 Tjrommel Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by Aric@Injected View Post
This is from our test car 2013 5 Door DCT. 100% from the factory. The blue lines are factory calibration (speed limiter raised and rev limiter raised) with 87oct fuel. The red is with 93oct fuel and our cal file.

ALL runs were made with the hood down, starting run ECT temps ~200*f, 4th gear, and completely stock hardware on the vehicle.
What's the power output difference in the mtx-75 and the DCT?
Tjrommel is offline  
    Reply With Quote
Reply

Bookmarks & Social Networks
-->
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:18 AM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Terms of Use : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Acura TLX or Fiesta ST. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.