Focus Fanatics Forum banner

Will these rims fit?

2K views 12 replies 6 participants last post by  thenorm 
#1 ·
#2 ·
That setup will "fit" however

the adapters will make the wheels stick out one inch further. not too big of a deal if you like that look.

The rims are a 0mm offset, stock focus rims around around 50mm (give or take a few mm depending on which stock rim) 50mm is just under 2 inches. so add that to the adapter that rim, and they will be sticking out of your fender almost 3 inches.

So it will "work" yet its not a good idea at all.
 
#4 ·
even with +25 offset wheels that spacer will kill you (its 1inch = 25.4mm)

use this to figure out a good fitment: http://www.rimsntires.com/specs.jsp


40mm offset on a 16x7 is a safe fit with a 205/50 while still looking aggressive. a 16x8.25 at 0 offset will stick out a lot. There is a happy medium between the two if you dont mind fender rolling/ pulling/ stretched tires and a lot of comber. Hopefully someone will chime in with specs for that, or just search
 
#13 ·
those were probably mustang wheels, which usually means they have the wrong offset too.

at some point it becomes easier to look at back spacing. (as opposed to offset)

look for 5.5" to 6" backspacing. if you need spacers, then a 6.5" backspacing would work.

however these are rare wheels, as no car has that fitment naturally.
 
#9 ·
Those adapters wouldnt work anyway as they go from:

Vehicle: 4x4.5 / 4x114.3 or 4x100
to
Wheel: 4x4.25 / 4x108

you would need the opposite going from the 4x108 to the 4x114.3 or 4x100
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top