finally starting my journey to 450whp

[focusmaniaczx3]

thanks jim i really appreciate it.

[Turbo Turtle]

got the intercooler and 35r in today. still waiting on those flanges from bmc



Tim

[focusmaniaczx3]

looking good! how tight is that going to be behind the roush fascia? are you going to have to trim it some?

[Turbo Turtle]

no idea how tight it is. i doubt i will have to trim it cause that bumper is HUGE lol. i will be checking fitment on that after i get a couple more pipes i ordered in. had to get a 75deg bend. i will probably get a stock bumper from pull a part to make sure it will fit good with that

Tim

[Turbo Turtle]

i think it will fit just fine. i may need to trim a little on the bottom where the opening curves back in toward the ic



did you wire these headlights up? makes it a pain to not be able to remove them lol. little bit ghetto there on the wiring...

Tim

[Turbo Turtle]

apparently agp also makes housings for the bullseye turbos

Compressor Specs:
- AGP Cast ported shroud housing 4" inlet 2" outlet
- Borg Warner 61mm extended tip compressor wheel 70lbs/min

Turbine Specs:
- AGP Cast T31 4 bolt outlet T3 turbine housing available in .48, .63, and .82 A/R ratios
- AGP Cast 3" V band outlet twin scroll T3 housing available in .55 and .75 A/R ratios
- AGP Cast 3" V band outlet T3 housing available in .63 and .82 A/R ratios
- Borg Warner 2.54/2.92 turbine wheel

that is apparently a 700hp rated turbo with a .48ar option lol

[turbosvtfocus04]

That intercooler looks kinda small maybe it's just me. Idk

[Turbo Turtle]

27x7x3.5 3 in/out. that bumper does make it look small

even top speeds big ic on micheals focus looks small with a bumper like the rs or roush

http://sphotos-b.xx.fbcdn.net/hphoto...13859941_n.jpg

[turbosvtfocus04]

Ahhhh yes it does.

[Mother Focus]

I probably should be the least to talk about bumpers , LOL but think it is bigger than a Roush should be, might be the pic though.
Glad to see it start, new record on page 36, hahaha, intercooler's size is perfect.