SVT intake manifold

[pyroinsa]

Will the SVT intake manifold bolt on to the Zetec? If it does, would I have to mod it to fit. Will I see any improvement by adding the SVT intake manifold to my Zetec?

Thanks for your help guys

[1turbofocus]

You will have to slot the bolt holes to get the runners to line up properly , the bolt holes line up just fine
You will need a way to get the intake manifold runner control to open the short runners at just over 5000 rpm
In my opinion no it adds no performance to the Zetec engine

Tom

[pyroinsa]

Thanks Tom! Just trying to figure out what I can use off this SVT engine:)

[1turbofocus]

The SVT header is about it

Tom

[ZXthrizzle05]

Their mmanifold sux anyway. The only good part is the lower. The upper has little donutgasketsinsidewich can eventually get lodged into the head

[iminhell]

SVT intake manifold will support more power than any other stock manifold.
I never slotted mine and never had a single issue, 4'ish years on the stock head.

If you have it, the swap is worth it because it's free. It's not going to reduce power.