WTB: AEM intake - throttle body elbow - zetec

[Mile30]

I disassembled my cold-air intake to group it with a pile of parts due for the powdercoaters on Monday; but the rubber boot/elbow that connects the MAF section of the intake to the throttle body had become fused with the tube...

I asked the metal refinisher people to just cleanly slice the boot and remove it if worst-came-to-worse, so not to damage the tubing; he ended up bending the hell out of the end of the tube using a screwdriver AND ripped some of the rubber from the inside of the boot as he tore it off. Sooooo; now I can't even use the elbow again AND the tube was compromised!!! The chewed-end is facing the camera; YOU SEE IT?!?!


I need a new/used-but-safe rubber elbow for the throttle body-to-tube portion! And possibly a new upper intake tube (depending on how the finished job turns out!)!

Here's the part I need:




Can anyone oblige?!

[Sponsor]

[Buickboy]

I would measure the tube and the TB, go on ebay and look for silicone couplers. I found a 2.5" to 3" 90deg bend elbow for 15 shipped for my project, you can probably find something cheaper depending on sizes