For Sale: '00-'05 focus custom coilover setup.

[ST33zn]

Custom coilover setup for a 00-05 focus zx3/zx4.

Fronts are motorcraft struts, chopped off perches. Matrix sleeve style coilover sleeves with 450lbs spring rated coils. Top hat and bearing included for a quick swap.

Rear are monroe air shocks with airlines included. Simply lower the PSI for a soft like stock ride, or raise the PSI for a firm ride. These also eliminate rear sag when passengers ride. megan rear coilover adjusters with 400lbs springs and rear cups.

$200 obo, prefer socal locals, but can ship at your expense.


DSC03360 by DruMurda, on Flickr

DSC03359 by DruMurda, on Flickr

DSC03358 by DruMurda, on Flickr

DSC03357 by DruMurda, on Flickr

DSC03356 by DruMurda, on Flickr

[Sponsor]

[euro-bred]

How low can they go? Any pictures installed? Wouldn't the lower ride height on the Motorcraft struts damage them? How many miles?

[ST33zn]

I couldn't get that low on this set up, but it handled fairly well. The air shocks and coilover have less than 3k on them. The motorcrafts have about 7k; they're in decent condition, not blown. The motorcrafts would eventually get tax'ed running on 450lbs springs. All other suspension components are pretty solid.

here's a pic maxed out. keep in mind i'm running 16's with a 40 series sidewall, Very short. The wheel gap will close up quite a bit running typical 50 series on 16's or bigger 17 inch wheels.

DSC02084 by DruMurda, on Flickr

[jsavory1]

hey man I am interested do you think you can send me some updated pics. I live in Blaine Washington, don't worry i will pay for the shipping. Thanks -Justin-

[06Shadowgrey]

Ran a similar set up on my old cougar and was about 2.5" off the ground... Good starter coil kit!!!

[kienangeier]

I live in MD so how much would you charge for shipping? This would be a nice addition for me and will pay ASAP depending on how much you charge me for shipping.

[02svtf300]

would the front coil over sleaves fit on better shocks. like bilstein HD or koni yellow. looking for a starter auto cross and DD kit. be fitting with a set of 17" sparco wheels

[ST33zn]

Originally Posted by 02svtf300

would the front coil over sleaves fit on better shocks. like bilstein HD or koni yellow. looking for a starter auto cross and DD kit. be fitting with a set of 17" sparco wheels

it would be ideal to run this set up with bilsteins or koni's. I'd was planning on running this set up with koni yellows up front. The rear air shocks have identical stroke ratio to the koni yellow, and depending on PSI you can run as soft as stock to even more stiff than koni, and anywhere in between

[02svtf300]

Ive haven't messed with to much aftemarket setups how do the sleeves get put on an stay on.

[ST33zn]

With this sleeve set up; there's an additional sleeve at the bottom that makes it fit snug around the strut. Then there are O-rings that go between the strut and the the sleeve that make it even more snug. Lastly, there are small screws that pinch around the strut that prevent it from moving up/down and spinning. The sleeve can easily be removed and transfer'd onto another strut.