 |
 |
 |
||||||
 |
|
 |
||||||
|
Auto Cross, Drag Racing, Car Show, Awards & Prizes - Register Now! |
||||||||
|
|||||||
General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.
|
 |
 |
|
|
|
Thread Tools | Display Modes |
11-08-2012, 09:24 AM
|
#1 | ||||
|
Focus Enthusiast
 
|
Lug nuts on a 2012+
Are they metric? I can't seem to find the right size. 19MM or 20MM or is it American?
|
||||
|
|
|
Advertisement
|
Remove Advertisements |
|
Focus Fanatic
Fan#: 1
|
|
|
11-08-2012, 01:10 PM
|
#3 | ||||
|
Focus Enthusiast
|
No one has any info on this?
 Found it http://www.focusfanatics.com/forum/showthread.php?t=301632 But when I tried 19mm in the hardware store it seemed to tight. I bought 20 and that was too big. Off to Sears hardware on my way home. |
||||
|
|
|
|
11-08-2012, 04:48 PM
|
#4 | ||||
|
Focus Addict
|
Some possibilities
Different countries have slightly different tolerances The other is 19.5 mm which might do it is .76 of an inch , which is 3/4" inch Maybe due to some odd ball convention, maybe the flats are 3/4" while the thread is metric Just like if one purchased a socket set abroad, the drive is still 1/4" or 3/8" or 1/2" or etc, due to [I think] Snap-On was the first to market such a tool and then everybody copied it when the patent ran out |
||||
|
|
|
|
|
| Bookmarks & Social Networks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 04:00 AM.
 |
|
 |
||
 |
|
 |