screw it, svt header swap build

[sgtsmasher]

its actually funny you did bring this back cause it was in the shop last night and i got picks of everything to with the exhaust, im not home at the moment so ill post them in a bit. ill have the custom orp to flex to HFC to Res then the rest of the exhaust... and i got everything from mandrelexhaustsystems.com with no fitment issues other then orp, hense why i called it custom

[sgtsmasher]

im going to go from back to front with the photos just for the suspense factor hehehe

[xy0s08]

awe this look very similar to the issues i have been dealing with for well lets just say a long time. i made a pipe that goes from the SVT header to the stock flex pipe.. it can be done with a welder, a home made svt flange, some o2 bungs and a lot of time... looks similar to what i made!! make sure the o2 sensors are in there far enough and not blocked by anything

[sgtsmasher]

we made sure that the 02 and a/f sensor were in far enough

[sleepyboy]

Well you are clearly using a Zetec flex with the SVT header and of course that's why it wouldn't line up. I had to make a similar pipe to connect my SVT header to my exhaust using a old bent up ORP I got from a local member/friend. Be careful with your motor mounts. I split a poly mount and whacked the crap out of the PS rack. It's leaking now from the pressure lines. On the bright side the exhaust clearanced itself lol.

[sgtsmasher]

well that and its a complete 3" set up. from what ive read every where people tend to steer clear of 3" and go with 2.25-2.5 set ups. i said screw it, GO BIG OR GO HOME!