How do I take out the top grill piece without breaking it?

[JL330]

This piece?
http://carsiyo.com/wp-content/upload...rille-View.jpg

[Sponsor]

[Duncan1104]

I quit trying because mine just would let go and I really didn't feel like breaking it.

[JL330]

I knew if I bent it back any farther to see what the hell was holding it in place, it was going to be done for.

[MdOdd]

Are you trying to plasti dip it? If so just tape around it leaving about a half inch border on the black plastic...

[JL330]

I already did that, I'm trying to plasti dip the paint below and I want to make the masking process easier.

[dyn085]

I have been trying to get that biznatch out to fabricate my upper ram air. It makes me really mad.

Pro Tip- Ensure that you re-attach the hood release cable if/when you disconnect it before closing the hood if you have super-ultra man hands like me...#tightsqueeze

[JL330]

Originally Posted by dyn085

I have been trying to get that biznatch out to fabricate my upper ram air. It makes me really mad.

Pro Tip- Ensure that you re-attach the hood release cable if/when you disconnect it before closing the hood if you have super-ultra man hands like me...#tightsqueeze

I'm interested to see this upper ram air, and I have big man hands too, years of weightlifting and sports injuries have made them pretty thick.

[dyn085]

I'm going to fab up some fiberglass pieces, one to the upper air tract and one for the lower grill piece (when I do the Newmission Mod). The upper may also get a hole fabbed in above the whisker to not only add air to the tract but also give some of the air a straight shot.

The added benefit of the opening builds on the Bernoulli Principal, as most ram air intakes are designed around. May be a month or more down the road though, gotta make my stance right first...

[Chaos09]

You have to remove the bumper to get it out! PITA.

[dyn085]

Originally Posted by 2012-Focus

You have to remove the bumper to get it out! PITA.

SERIOUSLY? Please tell me you are joking...