FSWerks kit intercooler dimensions

[Fernando_221]

Hi,

Anyone have the information of FSWerks intercooler dimensions?
I'm starting a DIY turbo and would like to know a good IC size for Focus.
22" x 5.5" x 2.5" will be fine? Turbo is a GT28, will run at 8psi and stock internals. It's a 2.0.

Thank you

[1turbofocus]

Those sizes will be ok , the big thing is the location to get clean air and to box the cooler good to make the air go through it , doing this you can get cooler air , make he IC more efficient , make safer power

Tom

[Fernando_221]

Originally Posted by 1turbofocus

Those sizes will be ok , the big thing is the location to get clean air and to box the cooler good to make the air go through it , doing this you can get cooler air , make he IC more efficient , make safer power

Tom

Nice, I'll try to get it well located.

2.25" piping it's ok for turbo > IC > throttle body? I don't know what's the turbo engine outlet diameter, I think it's 2".

[Turbo Turtle]

turbo outlet size doesnt matter with intercooler piping. large piping will flow better but boost response will be slightly better with smaller piping. with a 28r i would either run full 2.5" ic piping with 3" maf housing or 2.5 hot side and 3" cold side

[koke'sfocus]

Yeah i m running like turbo turtle said 2.5 hot side 3" cold side with the fswerks ic the oulet and inlet r 2" but with my cfm tb (67mm) I don't have any issues with throttle response
Posted via FF Mobile