2001 Focus ZTS interior Gray leather

[Schroeder02]

Location Hampstead, MD
Price Best Offer
Contact Schroder02

I’m selling all the interior from a 2001 Sedan with gray leather, the interior is in ok condition for a car 11 years old, see photos. I would prefer to sell all the seats and door panels to one person if possible. Local pick up preferred.

[Sponsor]

[TriggersDawn]

Could you post (or email me) a picture of the rear of the rear seat back? I think the latching mechanism might be different and not work in my hatch.

Also, should your location be Hampstead, MD? Not ND

[Schroeder02]

Originally Posted by TriggersDawn

Could you post (or email me) a picture of the rear of the rear seat back? I think the latching mechanism might be different and not work in my hatch.

Also, should your location be Hampstead, MD? Not ND

I can tell you the Latch for a sedan is different than a Hatch. The Sedan latches in the middle of the seat back and not at the edges.

yep thanks its MD

[viney266]

These front seats do have the airbags in them as well!

[finalfantasy]

Those aren't 60/40 rears, are they? Like would they latch into a wagon?

[Schroeder02]

Originally Posted by finalfantasy

Those aren't 60/40 rears, are they? Like would they latch into a wagon?

The seat backs are 60/40 the seat bottom is not split. I don’t this it will latch in the wagon, the latches on a sedan are mounted at 3rd pints on the package self.

[Schroeder02]

bump,
I'll consider parting out miscellaneous bits.

Also I did not list it but the sun roof , seat belt air bags, fender liners fog lights. If you need it let me know.

[Schroeder02]

bump

[TriggersDawn]

These seats can be used in a hatch if anybody is wondering. The fronts should bolt in just fine and the rear bottom will also. Some slight modification is needed for the rear of the back seat since the mounting points are different and they do not have the buttons to release the seat. What I did in my hatch was take the leather cover off the seat and put it over my hatch seat backs. Then I had to cut holes in the upper corners for the release buttons and slits in the back for the latches and holes in the side for the piece that connects the seats together. It looks fine except for the holes that were in the upper part of the back for the old latches. Only noticeable if you are looking at them in the trunk. Also in the hatch, the middle seat belt is in the seat, so I lost that and now have a 4 seater.