Amp and Sub install

[pyroinsa]

So I decided to install a sub using the SVT box. For those that don't know the SVT box is only big enough for a slim 8". SvviftSVT said that you can cut it to fit a 10"

New toys:
Rockford Fosgate Punch 8" P35 subwoofer RMS 300W, Dual 4ohm only 2.66" deep.
Alpine 500 watt V-Power mono amp
And Dynamat!!! Not really Dynamat, but very similar lol



I started off by Dynamatting the inside of the box and outside:

Put the foam back in:

Here is the Sub:

Wired it:

Installed it:

Ran the wires out the back where the bolt was holding the factory sub in:

Used what little dynamat I had left on the fenderwell:


Here are my amps side by side, the one with the silver on top is a four-channel amp for the door speakers, Alpine only changed the color, I might plastidip the top of the four channel lol:

The install:

Cleaned up the wiring and covered it:





I will add some blue led's around the speaker grille and a blue led in the light box, I also need to level the floor a bit more, to account for the regular spare, but I am verrrry happy with how it sounds and looks.

[Sponsor]

[FocusedSlayer]

Nice job

[XxFocus SVTxX]

yea nice job im taking my stock 10 thats in there and replacing it with 2 12 alpine type R's can't wait

[pyroinsa]

Originally Posted by FocusedSlayer

Nice job

Thanks

Originally Posted by XxFocus SVTxX

yea nice job im taking my stock 10 thats in there and replacing it with 2 12 alpine type R's can't wait

Thanks, are you sure it's a 10"? I didn't know that the stock SVT sub boxes have different size subs

Pics when done or it didn't happen lol