For Sale: Ported and milled zetec cylinder head - Page 2

focaltech · 08-25-2004, 04:06 AM

You can use a thicker head gasket to lower compression.

I have sent pm's to jonszx3 and Aeris86.

bartlomiej · 08-26-2004, 01:39 PM

have you tested this head on a flow bench?

focaltech · 08-26-2004, 05:45 PM

Since I am doing numerous heads on a customer request basis, I haven't yet.

I plan to though, for the testing I want it will cost about as much as this head. I am stockpiling cash so i can get a full work up done on a head, then install it with some cams and dyno it. I will be doing this after my next head is sold.

focaltech · 08-26-2004, 06:00 PM

Quote:

Originally posted by bartlomiej
have you tested this head on a flow bench?

Also, I will tell you this.

I have installed FC, FS and ford racing heads and IMO my head is equal to if not better than the heads available.

I put alot of effort into my zetec heads and have invested alot of $ in tools and supplies to do a quality job.

drewzx3 · 08-26-2004, 06:18 PM

I have one but its not on my car yet. He does good work.

focaltech · 08-27-2004, 03:04 PM

Thanks drew.

focaltech · 08-27-2004, 04:03 PM

This head is sold.

If your interested in a zetec head built to your specifications, don't hesitate to contact me.

-Jeff-

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2000 Focus (Zetec) Will not start after replaceing the head gasket.	zredmon	General Technical Chat	23	09-14-2011 11:35 PM
For Sale: zetec head	badass3	Archive	9	10-06-2010 10:38 AM
For Sale: Ford Racing Zetec Head CNC Ported, Polished, Milled .0025"	starfuryt550	Archive	12	03-31-2010 06:23 PM
For Sale: ported and polished,coated zetec head (cheap)	1turbozx3	Archive	23	10-13-2009 10:42 PM