Boost controller question

[ZXthrizzle05]

i just installed my greddy boost controller. on my ex wastegate the bottom oprt goes to the IM and the top goes to the solenoid then from the solenoid to the back of the controller itself. this correct?

[Sponsor]

[1turbofocus]

If your Turbo is controlled by a Wastegate, you will be using the ports: COM & NC. The COM will lead to the top of the Wastegate. The NC will lead to a Vacuum Source. The last port not being used is the NO, this port needs to be open for ventilation. Remove any plugs in the NO port. Your Wastegate will have a side port that needs to be tapped into a Vacuum line as well

Tom

[ZXthrizzle05]

My solenoid has only two ports on it I have the ex wastegate going to the intake and then the other port goes to the solenoid

[1turbofocus]

Never seen a 2 port or worked with one

Tom

[ZXthrizzle05]

looks like matt plugged up the bottom port witha nut

[ZXthrizzle05]

terrible picture i know but its the best i could do when its pouring down rain outside and we have no sunshine for light