Automatic shift knob

[ZeeXfive]

ive looked far and wide then finally found one then the day i went to buy it its gone...do any of you have any suggestions or ones you like?

[Sponsor]

[pyroinsa]

I like the Ford Edge shift knob

http://www.tousleyfordparts.com/part...t=Shift%20knob

It's what I have:

[distroy3d]

Looks good. Do you have any other pictures of the knob? And how hard is it to install?

[TerryB]

I have a Momo shift knob.
http://www.focusfanatics.com/forum/s...threadid=49120

[pyroinsa]

Originally Posted by distroy3d

Looks good. Do you have any other pictures of the knob? And how hard is it to install?

Thanks! It was really easy to install. Just unscrew your old one and set this one on and re-drill the new set screw location. You'll also have to cut off the end of the O/D pigtail and wire that to the new knob because the plugs for the O/D buttons do not match.

[distroy3d]

Looks amazing! Really gives the car a more luxurious look, while looking more OEM than most aftermarket shift knobs.

[CJohn364]

I have the Momo knob, as well.

[distroy3d]

Originally Posted by pyroinsa

Thanks! It was really easy to install. Just unscrew your old one and set this one on and re-drill the new set screw location. You'll also have to cut off the end of the O/D pigtail and wire that to the new knob because the plugs for the O/D buttons do not match.

Your link to the Tousley Ford site isn't working for me but I dissected the URL to try and figure out which part it directs to - is it the shift knob for a 2008 Edge SEL you bought? I went to "2008 - FORD - EDGE - SEL - BODY HARDWARE - CONSOLE - SHIFTER HOUSING - Shift knob" and there's only 1 for $39.80 MSRP, $26.27 online price.

And by "re-drill the new set screw location" I assume you mean I'm drilling a new hold in the original auto shifter shaft thingy using the hole from the Edge shift knob because it doesn't line up with the original?

And is it hard to rewire the OD? Or is it simply find which is +/- kinda thing and electrical tape/heat shrink them together?

[pyroinsa]

Originally Posted by distroy3d

Your link to the Tousley Ford site isn't working for me but I dissected the URL to try and figure out which part it directs to - is it the shift knob for a 2008 Edge SEL you bought?
http://tousleyfordparts.com/parts/20...t=Shift%20knob

And by "re-drill the new set screw location" I assume you mean I'm drilling a new hold in the original auto shifter shaft thingy using the hole from the Edge shift knob because it doesn't line up with the original?

simply find which is +/- kinda thing and electrical tape/heat shrink them together?

All that's a yes!

[distroy3d]

Awesome. $30 for a OEM-quality leather/chrome shifter is killer. Most of the garbage on eBay is >$50 and they look tacky/ricey. Definitely gonna' do this in the future!