Focus Fanatics Forum banner

Question about headlight light

2K views 2 replies 3 participants last post by  loudfocus01 
#1 ·
I just bought these headlights.



After a little work i got them installed and running but the light pattern was a little different from what im used to. Instead of a flat pattern, the light is more like __/ . Both headlights have that angle in the light. Anyone else run into this. Is this a problem?
 
See less See more
1
#3 ·
If they are anything like the ones i have, there should be two screws on the back of the housing on each side of the projector casing. It takes quite a bit of tweaking, but you'll figure out how each screw effects the light throw. I just adjusted mine last night, and it wasnt easy to figure out, but once I did, I got the light throw how i wanted it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top