SVT Focus 67mm Throttle Body

[Charged SVTF]

Will I need to run a larger MAF tube and need a diablo MAFia for the increased flow and intake? Also, will this actually be bigger than the inlet on the Jackson Racing Supercharger that this would bolt to?

Thanks CFM,

Tim

[Sponsor]

[finalley]

where you gettin a 67mm for your SVT??

[Charged SVTF]

Look at the above manufacturer lol CFM sells them

[finalley]

Daamn, I blinked. an two products reappear ,a new 67, and rumors of another run of 70mm's...

[cfmfocus2]

Originally Posted by connolly92

Will I need to run a larger MAF tube and need a diablo MAFia for the increased flow and intake? Also, will this actually be bigger than the inlet on the Jackson Racing Supercharger that this would bolt to?

Thanks CFM,

Tim

The inlet on the throtte body is 3 inches. I would recommend measuring the hose to the throttle body to make sure it is large enough. Some of our customers have said they were able to stratch the hose over the throttle body. I know the throttle body is fine for the stock svtf intake manifold. I would think the same is true for the JRSC, but you can take your throttle body off and measure the inlet on the JRSC to see if it is atleast 67mm. You would not need the MAFIA, as the computer will be able to adjust.

[blkthunder]

it should help a lot on your setup!

[Charged SVTF]

I know...just the holidays are tight for cash. My first time out on the track I ran 14.4 @ 99.78. That was with a horrible 60 ft of 2.398 Each tenth that i was off equaled about .225 on my ET. I figure with the TB ill see traps of 100mph plus easily and with a 2.2xx ill be in the upper 13's. Just need to get the $260 now.