i recently bought headlgihts dual with the halo rims off ebay..lookin good gonna paint them but didnt come with instructions about wiring the halos to......i was gonna slpice them in with the grille lights i also got some nuts bolts and washers dont know what them are for
if anyone has some tips to help me out thanx!!!
Black goes to ground and red goes to anything with 12VDC(Fog lights, turn sigs or you can wire up something to turn it on and off using a switch in the cabin.
Advise you put 300 or 330 ohm/half watt resistor in series with red wire or your halo's may burn up in a few months.
Look in the How To section on the main page of this forum. It's on the left hand side. This a Fog Light Mod to allow you to turn on your fog lights without the HL's being on.
As dank said, the adjuster screw should move the HL up and down.
Turn the adjuster toward the driver side to make them go up and toward the passenger side to bring them down. It takes a lot of turns to see any adjustments.
Use the link below to help align your HL's. If the screw does not adjust the HL's, you may have a broken adjuster.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Focus Fanatics Forum
5.8M posts
189.1K members
Since 2003
A forum community dedicated to Ford Focus owners and enthusiasts. Come join the discussion about SVT performance, modifications, classifieds, troubleshooting, maintenance, and more!