Focus Fanatics Forum banner

Rear sway bar end links and bushings.

4K views 11 replies 6 participants last post by  Gettysburg150 
#1 ·
#3 ·
the bushings should work. we have a 20mm bar. as for the endlinks im not too sure. but i bought endliks for an asvt and they work so who knows
 
#4 ·
Sugested solution

What I did with my ford aspire was I went to Moog's web site and found their p/n and went to NAPA's web site and converted the p/n and then call the counter for a stock check. This was for lower control arm bushings but I had them in my hand in about two and a half hours start to finish. I am not endorsing either of these vendors just trying to offer a method to resolve your problem.
 
#8 ·
Yeah I do not believe they are greasseable. BUTTTTT..... if you go to a hardware store and get the zerk fittings, you can just drill and tap them and BAM, greaseable
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top