When i take the wideband 02 out of the last bung should i plug it? or put the stock 02 back in?
I read in the innovate manual that its not good to run the sensor in the pipe if its not hooked up. Somthing about the heater needs to be hooked up and heating or it would ruin the sensor. Not sure if the stock ones are like this or not?
Right now Tom has the last sensor turned off, but does that mean its just not sending data? or not heating either?
Ill need to plug the hole either with the stock sensor or a plug.
The local muffler shop wont do it. They said they cant weld into cast iron.
They said the manicat would have to come off and if i went threw all that ide just have a header put on insted.
Looks like thats my next step.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Focus Fanatics Forum
5.8M posts
189.1K members
Since 2003
A forum community dedicated to Ford Focus owners and enthusiasts. Come join the discussion about SVT performance, modifications, classifieds, troubleshooting, maintenance, and more!