Originally Posted by VH5150
Pics and directions on removal aind install, please.
I decided not to vinyl it yet, however, I did remove the pieces to test. I have to run to a BBQ but here are the pics
U need a thin plastic trim removal tool tp try it out the pieces. BE CAREFUL SOME OF THESE CLIPS SNAP IN PLACE SIMILIAR TO A WIRE HARNESS CLIP. FOLLOW SILVER PONY PICS. On a scale of 1-10 with 10 being the hardest.....2
Wire Harness on the control unit
STILL THE CONTROL UNIT
The black cable is the mic i think or air sensor. It disconnects/unclips from the top. DO NOT TRY TO PRY IT OFF THE CONTROL UNIT AS SHOWN!
AGAIN DO NOT TRY TO PRY THE THE PART THAT SAYS TO SPEAKER OUT!!!! The control unit hangs from this wire when you unclip the wire harness. Below you will see the small speaker wire and the plug its slips into.
Once you have the controls out the frame just unclips. Just take your time.