Fawzie13R, I believe your drum setup is very similar to mine. On the rear of your drums there are 4 bolts you have to remove to completely take the drum off. There are also two spot welds that must be drilled out. There should be one weld between the top two bolts and one weld between the bottom two bolts.
I would suggest doing a bit more reading before investing in parts. I remember reading somewhere on these forums that those 4 bolts on the 08 and up might be slightly larger than 07 and earlier. Based on that, I am not completely sure an earlier year disc setup is a direct bolt on, without drilling and rethreading those holes.
Hope this helps, good luck.
MTX-75 swapped, Exedy OEM clutch kit, 05 front brakes, VF Engineering mounts, tint, fog lights, cosworth cai, custom 2.5" exhaust, focussport upper stress bar, ground control/koni yellow coilovers, more to come