 |
 |
 |
||||||
 |
|
 |
||||||
|
Auto Cross, Drag Racing, Car Show, Awards & Prizes - Register Now! |
||||||||
|
|||||||
General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.
|
 |
 |
|
|
|
Thread Tools | Display Modes |
03-04-2013, 02:10 PM
|
#1 | ||||
|
Focus Rookie
 |
no spark
2003 spi just replaced. Turns over fine, nice and strong. Will not fire. Sprayed starter fluid in teh TB, no change. I can hear fuel pump energize. Pulled # 1 plug, held near manifold, no spark. Where do i start?
|
||||
|
|
|
Advertisement
|
Remove Advertisements |
|
Focus Fanatic
Fan#: 1
|
|
|
03-04-2013, 07:25 PM
|
#2 | ||||
|
DTC P0606
 
|
Check for spark at the other cylinders. If there's no spark at any plug, it's either coil failure or the coil isn't getting 12V. You should see 12V at the center wire of the coil connector plug with ignition on.
Last edited by BC_ZX3; 03-04-2013 at 10:03 PM. Reason: spelling |
||||
|
|
|
|
03-04-2013, 08:51 PM
|
#3 | ||||
|
FF Affiliate
 
|
I would check the crank trigger sensor first , if it looks good on the end (remove to check it) then next check the coil plug in for loose or broken wires
Tom
__________________
Focus-Power: Your #1 Source for Ford Focus Speed, Tuning & Performance! Customer Support AIM: hpdyno Email: tom@focus-power.com Phone: 704-249-3745 Site: focus-power.com Elder 1turbofocus |
||||
|
|
|
|
|
| Bookmarks & Social Networks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 05:15 PM.
 |
|
 |
||
 |
|
 |