|
||||||||
|
Auto Cross, Drag Racing, Car Show, Awards & Prizes - Register Now! |
||||||||
|
|||||||
MK3 Focus The place to chat about general questions, window tinting, exterior body, interior and lighting upgrades for the third generation 2012-Current Focus.
|
![]() |
![]() |
|
|
|
Thread Tools | Display Modes |
|
|
#1 | ||||
|
Focus Addict
|
My new 2013 foggy headlights
Hey guys, anyone else having this same issue? Both my headlights do this from time to time. Brand new 2013 Focus, original headlights that came factory on the car.
![]()
__________________
2013 Focus SE Sport Black Pack 2012 Mustang GT Paxton supercharged 589rwhp |
||||
|
|
|
|
|
Remove Advertisements |
|
Focus Fanatic
Fan#: 1
|
|
|
|
#3 | ||||
|
Focus Enthusiast
|
Read the owners manual. Some fogging is acceptable, as long as (I think) less than half of the light is fogged and also as long as there are not visible water droplets.
__________________
Mods: Drop in K&N filter, Steeda RSB, MS3 RMM, Remote start, Llumar tint, Ti engine cover, Husky floor mats, OEM splash guards |
||||
|
|
|
|
|
#4 | ||||
|
Focus Enthusiast
|
My warranty told me it was acceptabl so I just re siliconed it.
|
||||
|
|
|
|
|
#5 | ||||
|
Focus Fanatic
|
They have a vent hole built in for humidity to escape. It's never happened to me but supposiy if they get foggy leaving them on to heat up and evaporate moisture out could work.
|
||||
|
|
|
|
|
#6 | ||||
|
Focus Addict
|
I wouldn't be surprised if it was the vent hole causing this. It's cold outside but I took those pics after a 45 minute drive with the DRL's on
__________________
2013 Focus SE Sport Black Pack 2012 Mustang GT Paxton supercharged 589rwhp |
||||
|
|
|
|
|
#7 | ||||
|
Focus Enthusiast
|
From page 126 of the Owners Manual
Lamp assembly condensation Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a thin film of mist can form on the interior of the lens. The thin mist eventually clears and exits through the vents during normal operation. Clearing time may take as long as 48 hours under dry weather conditions. Examples of acceptable condensation are: • Presence of thin mist (no streaks, drip marks or droplets) • Fine mist covers less than 50% of the lens Examples of unacceptable moisture (usually caused by a lamp water leak) are: • Water puddle inside the lamp • Large water droplets, drip marks or streaks present on the interior of the lens Take your vehicle to a dealer for service if any of the above conditions of unacceptable moisture are present. |
||||
|
|
|
|
|
#8 | ||||
|
Focus Addict
|
Funny you mention this. I'm getting both my headlamps replaced tomorrow (parts finally came in). Both of mine, in particular the left front headlamp has been fogged over for almost two weeks. I know we've had our "winter weather" down here, was warm then cold and rainy for a solid week. But the left front still hasn't cleared up. Took it to the dealer because it got frustrating to see it like that everyday. Brand new car (year old) replace this please, they are, thanks.
|
||||
|
|
|
|
|
#9 | ||||
|
Focus Addict
|
Quote:
Let me know how it goes please. I'll be talking to the dealership I bought the car from as well. Does anyone have a list of TSB's for 2013 Focus?
__________________
2013 Focus SE Sport Black Pack 2012 Mustang GT Paxton supercharged 589rwhp |
||||
|
|
|
|
|
#10 | ||||
|
Tasty Red Meat
|
yeah, i have had a bit of light fogging
__________________
ST Crew #11 / SSR #5 Official Mayo Hater #1 Randomie's Lover #8
|
||||
|
|
|
|
| Bookmarks & Social Networks |
| Thread Tools | |
| Display Modes | |
|
|
|
||||