 |
 |
 |
||||||
 |
|
 |
||||||
|
Auto Cross, Drag Racing, Car Show, Awards & Prizes - Register Now! |
||||||||
|
|||||||
General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.
|
 |
 |
|
|
|
Thread Tools | Display Modes |
11-23-2012, 03:26 PM
|
#1 | ||||
|
Focus Enthusiast
 
|
P0135
Anyone come across this before. I checked the fuse #18 under the hood and it is good. O2 sensors (there seem to be two bank ones) are new but that doesnt mean one cant be bad. Any thoughts by anyone or has anyone had this problem before?
|
||||
|
|
|
Advertisement
|
Remove Advertisements |
|
Focus Fanatic
Fan#: 1
|
|
|
11-23-2012, 07:41 PM
|
#2 | ||||
|
Focus Fanatic
 
|
Quote:
__________________
Interduce Mr. Torsen to the mix  D23 crew- D-Tech- Sedan Revolution= #131
|
||||
|
|
|
|
11-24-2012, 07:35 AM
|
#3 | ||||
|
FF Affiliate
 
|
Any mods on the car , any Vac leaks , both these could cause your issue ???
Tom
__________________
Focus-Power: Your #1 Source for Ford Focus Speed, Tuning & Performance! Customer Support AIM: hpdyno Email: tom@focus-power.com Phone: 704-249-3745 Site: focus-power.com Elder 1turbofocus |
||||
|
|
|
|
11-24-2012, 08:48 AM
|
#4 | ||||
|
Focus Enthusiast
|
Only mod on the car is CAI (AEM) and cat back exhaust stock diameter. Did find a broken hose on the runner and fixed it but car still a little jerky and running rich. So I just ordered two new upstream O2 sensors and will just replace both, clear codes and see what happens. Also checked the air straitener on the MAF tube and cleaned the MAF. Car has new coils, wires, plugs, and will have all new O2 sensors (again).
|
||||
|
|
|
|
11-24-2012, 03:49 PM
|
#5 | ||||
|
Focus Enthusiast
|
Ok read codes again and this time no PO135, instead I have a 107 (barometric pressure sensor low), a 122 (TPS Circuit low) and a 190 (Fuel Rail Circuit something or ruther) Now these are all pending. Any thoughts. MAP sensor bad? Cleared codes again and keep getting a P0122. So I am thinking still could be the MAP sensor but also the TPS sensor. O2 sensors are fine and working. Bought a FC throttle body online and a new TPS will see if that fixes the problems, along with a new MAP and MAF sensor. The car has a butt load of miles on it 180K+ and I only spent like $750 buying it so it wont hurt to replace most of the important sensors anyway. When is the radiator fluid recommended to be replaced. I should probably do that too! And a new fuel filter.
By the way anyone know where the MAP sensor is located on the 2.3?? Last edited by focusmachnone; 11-26-2012 at 06:28 PM. |
||||
|
|
|
|
12-06-2012, 11:13 AM
|
#6 | ||||
|
BodyKits=PantiesDrop
|
Its on the front of the intake manifold.
__________________
Looking for 17x8 wheels to race on! PM me if you have something! Disciple of the "Push harder, suck less" school of autocross. 173.4whp gumpcrew #6 |
||||
|
|
|
|
12-09-2012, 10:40 AM
|
#7 | ||||
|
Focus Enthusiast
|
Thanks replaced O2s not throwing that code any more. Instead a butt load. look up thread called the code thrower.
|
||||
|
|
|
|
|
| Bookmarks & Social Networks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 10:07 PM.
 |
|
 |
||
 |
|
 |