Incognito27`s 2003 ZX5 Build

[pyroinsa]

Whats the GA part?

[stealthzx3]

Shh i'll post it in my build thread since you bumped it :p

[Incognito27]

Not much of an update today , i did half the wireing harness , on the headlights .

Basically cut , and solder and added connectors to make it easy to remove if i need to. Monday i will take my old bumper and headlights off and start the wireing on the car , to mate with the wireing on the lights , will post a picture of everything before it goes on the car so you can see my mad skillz with a soldering iron and connectors :P

[stealthzx3]

What do you need a harness for? I just hardwired the lights into the factory signals and power wires

[Incognito27]

i want to keep connectors so if i want to remove the headlights i can. the new headlights don`t just plug into the original harness. i have to cut and add new connectors.

[stealthzx3]

Gotcha, and good thinking. Take a pic of the harness you make, i'm interested to see it

[Incognito27]

i will surely do that.... ( and no i did not call you shirley)

[Incognito27]

So as you recall last, i was stoked about installing the new bumper and headlights , but before i could do that i had to finish making my wire harness. Well wire harness done , headlights in , bumper on. But LEDS are not connected yet. that i will have to do tomorrow , ran out of day light.

However i won't leave you Pic less. here is the wire harness. I used Trailer wire harness's to remake a harness for the new headlights. I soldered every connected and used electrical grease in every connector to protect them even more. I will say though that the lights look awsome. Brighter by a long shot. will change the turn signal to a LED light rather than what i am useing. However tomorrow i will hook the LEDs up and then take a few pictures for you all to see.

[stealthzx3]

Looks good!

[Incognito27]

was weird when i had it all installed and was doing a test lighting to make sure everything worked. and one light the high beam was set as low beam and opposite the other , so i had to do a little quick emergency wire cut and re solder. was weird because i they were identical. But in the end was good. Tomorrow will see some nice pics. wanted to get a car wash today but both the washes were closed cause they was broken... they were accross the street from each other.... weird.

Also ordered SVT fogs today from Rock auto