koke's turbo kit build

[1turbofocus]

PLEASE take off the filter and adaptor and remove all the silicone , give me a call tomorrow afternoon and I will go over why and what it can do

Tom

[koke'sfocus]

But what can happen? It's hi temp rtv And I don't have any leaks
Posted via FF Mobile

[ZXthrizzle05]

minus the rtv sealant your build looks sick

[koke'sfocus]

Thanks :) hey so u think that it will leak?

Originally Posted by ZXthrizzle05

minus the rtv sealant your build looks sick

Posted via FF Mobile

[sleepyboy]

Not leak but pieces can flake or break off and get stuck in the bearings of the motor or turbo and block a oil passage. None of those is a good thing. Why did you even put it on in the first place doesn't it have a O ring on it already?

[koke'sfocus]

Oh ok I don't think is gonna happen I carefully put the rtv in the sandwich and nope it didn't came with a o ring

Originally Posted by sleepyboy

Not leak but pieces can flake or break off and get stuck in the bearings of the motor or turbo and block a oil passage. None of those is a good thing. Why did you even put it on in the first place doesn't it have a O ring on it already?

Posted via FF Mobile

[ZXthrizzle05]

That's odd it shoulde came with an O ring....it shouldn't leak either....the only place I used rtv sealant was. For the new oil pan with the bung welded in. And I used ALOT

[koke'sfocus]

Yeah it was weird :s but it doesn't leak at all and I carefully put the rtv were the o ring should go I'm tuning the car next Wednesday hopefully (finger cross) the only thing is that I have a small leak in the drain line cause it was like 1 inch short but i already got one I'm putting it in tOmorrow and it smokes alittle some times I have a restrictor but I don't really remember the size I already bought one too
Posted via FF Mobile

[ZXthrizzle05]

if its a journal bearing turbo it needs a .065 restrictor.

[sleepyboy]

Be careful using a lot of RTV. I did before and found some of the RTV in my pickup tube before. Just use a 1/4" bead of it on the oil pan and let it set up before installing it. If you let is set up it won't squish out everywhere and make little beads that could get broken off.