piston and rod upgrade question
ok, so i'm in the Army deployed in Afghanistan right now and i'm working on plans for my svt when i come back. its got a bit over 101k miles and i bought it at 91k so i don't know the history of it. from the repairs i've done so far, whoever previously owned it didnt know car maintenance at all (purchased from a guy who bought it at an abandoned car auction).
as for right now, im planning to stay NA. i want this car to last a long time and have more power, so i'm thinking i will upgrade pistons and rods when i come home with a little extra deployment money. i've been looking at this kit: https://focus.c-f-m.com/jepistonswit...vtst170-2.aspx
however i'm not sure what compression ratio to go with. any advice would be great.
also, if i do this i'm thinking of replacing the head gasket as well with one of these: https://focus.c-f-m.com/newitemcomet...csvtst170.aspx
however again, i'm not sure what numbers and measurements to go with.
K&N Typhoon SRI, Magstar 8.5mm plug wires, Denzo Iridium plugs, all VF Eng poly motor mounts, 2.5" Dominant Eng HFC & flex pipe, Trubendz 2.5" exhst w/ Borla muffler no resonator, SCT Xcal3 with Tom's Tune, CFM 67mm TB