spectre kit help

[sam fisher]

so i bought a 60 degree bend , a 90 degree bend and spectre filter ,
as specified in this thread which is probly the best stealth cai iv seen .

http://www.focusfanatics.com/forum/s...ght=pvc+intake

BUT there is a tiny problem lol . spectre doesnt sell a coupler bigger than 3 " , thats a little too small to attach onto the stock maf tube .

so i guess all i need to know is what should i use to join the filter and bends to the maf tube?

[Sponsor]

[boardgeneration]

I bought the spectre kit and used 3" couplers they had at autozone. Worked fine for me.

[boardgeneration]

Oh shoot! Yea I actually cut the wide part of the maf tube with the honey comb off and coupled it onto the spectre kit. Sorry I forgot about that.

[sam fisher]

Originally Posted by boardgeneration

Oh shoot! Yea I actually cut the wide part of the maf tube with the honey comb off and coupled it onto the spectre kit. Sorry I forgot about that.

good stuff , see i dont know why but the 3 inch spectre coupler was just too small , i tried boiling it and forming it around the maf tube , and i also tried a heat gun , the thing just would not budge .

[sam fisher]

Originally Posted by boardgeneration

I bought the spectre kit and used 3" couplers they had at autozone. Worked fine for me.

i also see that in your pic your maf tube looks to be a little smaller than mine because i have the same couplers and its just too small , edit: wait did you even retain your stock maf tube , now that i look harder , is the maf going into the kits tubes? i am going to keep my maf tube .

[sam fisher]

i still have to finish it so i will try to take some pics to post up

[boardgeneration]

I used my stock maf tube. However the top section of it was over 3" and I couldn't fit the coupler over it.
I took a dremel to the section of the maf tube that holds a honeycomb screen. I cut off a total of maybe two to three inches. If u look at the stock tube you will see there is plenty of tube to couple onto if u cut that top wide section off. However there's no reusing it on the stock air box obviously.

[sam fisher]

Originally Posted by boardgeneration

I used my stock maf tube. However the top section of it was over 3" and I couldn't fit the coupler over it.
I took a dremel to the section of the maf tube that holds a honeycomb screen. I cut off a total of maybe two to three inches. If u look at the stock tube you will see there is plenty of tube to couple onto if u cut that top wide section off. However there's no reusing it on the stock air box obviously.

just did that , i would post the pics but i have no idea how to do that on here , when i click insert image it tells me to type in a g url .

[sam fisher]

also , do you have anything supporting the setup or is it free-hanging? im not sure how im going to support mine

[boardgeneration]

The stock maf tube clamp fit correctly the way I set mine up.

As for posting images, take ur pic. Upload it to photobucket. Click on the pic once it's on photobucket and copy/paste [IMG] URL to ur post. That's it.