stage 2 cams on PWSC

[00_focus_Zx3]

Has any one had the crower stage 2 forced induction cams on there powerworks or Jackson racing supercharged cars? I have a pair sitting in my garage for the last couple of years I've wanted to put them in but never wanted comprise my smooth idle so if you have used these cams let me know how they were and if there was a good increase in power

[Sponsor]

[00_focus_Zx3]

no one has done this set up?

[1turbofocus]

Yes it has been done many time , sense you already have then there and I am guessing dyno adjusted with Adj cam gears then I would leave them there

If some one was to ask me if they should install them with a jrsc I would say no

Tom

[00_focus_Zx3]

Ah sweet thanks for the advice but how did it effect the cars idle?

[02ztsian]

I had Crane St 2 cams on my PW ZTS with standard PW tune; had adjustable cam gears but never moved them from 0°/0°. Put down 208hp/186tq @6700 (and still climbing) with only 8½lbs observed boost on a Mustang dyno.
No change in idle quality-more was there with a better tune and raised rev limiter.