Mazda3-5 MS3 MotorMounts Fit 2012 Focus

[TORQUERULES]

True, true. I am going to order mine next week to try.

[andcool69]

Originally Posted by amoosenamedhank

Well I just said eff it and picked up a OEM MS3 mount for $25 shipped and ordered a set of CS inserts. Not a bad option for $66.

This is what I'm going to do lol out of curiosity where do you order the oem mount from?


Sent from my iPhone 4S

[amoosenamedhank]

Originally Posted by andcool69

This is what I'm going to do lol out of curiosity where do you order the oem mount from?


Sent from my iPhone 4S

I got it used on mazdaspeedforums.org. You have to be a premium member to access their classified section however. There are other mazda forums out there. However, just be sure you're getting a mazdaspeed 3 mount and NOT a Mazda 3 mount.

[andcool69]

Originally Posted by amoosenamedhank

I got it used on mazdaspeedforums.org. You have to be a premium member to access their classified section however. There are other mazda forums out there. However, just be sure you're getting a mazdaspeed 3 mount and NOT a Mazda 3 mount.

Yea most of the forums are like that. I did find it on another site. It does say it is the Mazdaspeed one but I am not entirely sure. Mind taking a look?

http://www.car-stuff.com/store/mazda...tings+Page%3A3

Thanks guys!



Sent from my iPhone 4S

[amoosenamedhank]

Looks like a standard Mazda 3 mount. The MS3 should only have 2 windows in between the rubber. This mount has 3.

[andcool69]

Originally Posted by amoosenamedhank

Looks like a standard Mazda 3 mount. The MS3 should only have 2 windows in between the rubber. This mount has 3.

Ok what about this one? It is a complete aftermarket one for the ms3?

http://store.awrracing.com/engine-mount-mazda3-ms3-mazda5-rear/

Sent from my iPhone 4S

[TORQUERULES]

Originally Posted by andcool69

Yea most of the forums are like that. I did find it on another site. It does say it is the Mazdaspeed one but I am not entirely sure. Mind taking a look?

http://www.car-stuff.com/store/mazda...tings+Page%3A3

Thanks guys!



Sent from my iPhone 4S

That is a standard 3 mount. 2 slots in rubber= MS3. 3 slots in rubber= regular 3.

A pic of my mount:

[TORQUERULES]

Originally Posted by andcool69

Ok what about this one? It is a complete aftermarket one for the ms3?

http://store.awrracing.com/engine-mo...3-mazda5-rear/

Sent from my iPhone 4S

That will work, but it has the rubber replaced with solid urethane. The lowest it goes is 70 durometer. A lot of vibration unless you could care less about that or plan to race a lot at the strip.

[andcool69]

Originally Posted by zx3matt

That will work, but it has the rubber replaced with solid urethane. The lowest it goes is 70 durometer. A lot of vibration unless you could care less about that or plan to race a lot at the strip.

yes i know, i was looking at that. probably a little rough for me. thanks for the help though!!

[Power Surge]

Anyone tried filling the stock mount with urethane? Back in my SHO days, there were no aftermarket mounts, we all used to make our own mounts out of stockers with urethane.

Matt, would you part with your stock mount?