Exhaust Tip

[fordnut02]

Got mine from our local walmart today, it was on clearance for 6.00 .

lucky me , lol

[fordnut02]

Originally Posted by mcg80

I found this at Pep Boys, $8.95, open package otherwise 16.99. In the picture it's just sitting on the pipe. I can move it back/up a bit further but I may need to trim the end of the OEM pipe about a 1/4-1/3 inch. The back of the pipe is black and the red stripe is removable. I like the fact that it doesn't face down but out.
Opinions?

I saw that 1 today, at pep boys , had it in hand , and changed my mind , but looks good .

[BiggerBoat]

Originally Posted by mcg80

I found this at Pep Boys, $8.95, open package otherwise 16.99. In the picture it's just sitting on the pipe. I can move it back/up a bit further but I may need to trim the end of the OEM pipe about a 1/4-1/3 inch. The back of the pipe is black and the red stripe is removable. I like the fact that it doesn't face down but out.
Opinions?

Looks sharp to me. I might lose the red stripe but it's not too bad. I am also thinking I may need to cut some of the OEM pipe for the tip I got (pictured below, ebay link in previous post) but have been squeamish about doing so.

[Duffman355]

^^^ post a pic when you're done. Curious to see that. Btw . . .



That was a bit more than $9.00 though.

[BiggerBoat]

Originally Posted by Duffman355

^^^ post a pic when you're done. Curious to see that. Btw . . .



That was a bit more than $9.00 though.

Will post a shot as soon as I get the nads to chop off (or paint black) the OEM tip. Have you posted any underside shots of yours cause that looks like a cat-back re-do.

[Sargetalon]

Also from Pepboys

[FocusBoy58]

Originally Posted by BiggerBoat

Will post a shot as soon as I get the nads to chop off (or paint black) the OEM tip. Have you posted any underside shots of yours cause that looks like a cat-back re-do.

lol its a rear lunchbox delete.

[r1derbike]

I also have to eat crow on this one. Picked one up, wrestled a bit to get it as far on as possible, without breaking anything, checked for any obstruction internally, and done.

You want to remove the hardware to make it easier to slide on, and jostle into position, then reattach and tighten the hardware.

It looks as good as the stock 65.00 tip that came with my '10 SES.

And all for 10 bucks. Who woulda thunk?

[Fuzzy Logic]

just put the walmart one on... for $10 it's a cheap visual upgrade over the dull stock tip. it'll do until i put on a real c/b.

[jsphtn8]

For those who used the tip from walmart. Did you use the bracket or just the screws? I had trouble using both brackets. I ended up putting only ome of the brackets and just the screw on the other side.