Vehicle tattoos for the all-new 2012 Ford Focus

[2010SVT]

Originally Posted by misfire

i say yes, but not to the graphics they are offering.

I'm with you there bro. The ones they are offering look like poop. I'm sure if they had some nice cool designs it would look sick. But hey, if thats what someone wants to put on their vehicle whatever, as long as they like it I guess.

[Lillian]

I like the Red one! the 4th picture! very beautiful~

[RKZX2]

how about this?

just make sure you don't take an arrow to the knee. lol!

[InkMyWhip]

There is only one original.

[budpln]

its cool for girls id say its gunna get alot of customers into ford.. plus its gunna make alot of people appreciate there cars more id say its a good move on fords part..

[HOTFOCUS101]

Aww cute, were they hard to install ? Is that one vinyl ?

[swfst]

I kinda like the off center stripe in black.

[Dgc333]

Originally Posted by HOTFOCUS101

Aww cute, were they hard to install ? Is that one vinyl ?

I have applied vinyl graphics on a bunch of cars over the years. They are not hard to apply. Simple ones like the bubble graphics on my wife's Focus I posted a picture of is quite easy because it's made up of a bunch of pieces. The Flame graphic I put on the PT Cruiser she drove before the Focus was more involved and required a helper because it covered a good portion of the sides of the car.

The trick is to use a little dish soap mixed with water that you spray on the surface. This allows you to move the graphic around and makes it easier to squeegy the air out from underneath.

[HOTFOCUS101]

Originally Posted by Dgc333

I have applied vinyl graphics on a bunch of cars over the years. They are not hard to apply. Simple ones like the bubble graphics on my wife's Focus I posted a picture of is quite easy because it's made up of a bunch of pieces. The Flame graphic I put on the PT Cruiser she drove before the Focus was more involved and required a helper because it covered a good portion of the sides of the car.

The trick is to use a little dish soap mixed with water that you spray on the surface. This allows you to move the graphic around and makes it easier to squeegy the air out from underneath.

I really am looking at a pin strip of barb wire .. saw a few i liked ...

[Dgc333]

Something like that because it's thin may be a little more difficult to get straight without any wavers.