How to Fit a Double Din in a 00-04 Focus - Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace

Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > Car Audio, SYNC, MyFord Touch & Electronics

Car Audio, SYNC, MyFord Touch & Electronics The Forum for the Ford Focus audiophiles. The place to chat about automobile sound systems, security systems, or show off your I.C.E.!
Sponsored By: GT Sound Control

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-17-2010, 05:43 PM   #1
Focus Addict
Deaner's Avatar
Join Date: Sep 2006
Fan#: 39531
Location: League City, TX
What I Drive: 2002 ATX Twilight Blue ZX5

Posts: 1,467
FF Reputation: 31 Deaner Great Standing Member
Buy-Sell-Trade Rating: (8)
How to Fit a Double Din in a 00-04 Focus

Warning: This install will not allow you screw your bezel into place. If you require the bezel to be screwed in, you must modify the bezels face for the radio to slide in from the front rather than the back.

I am NOT held liable for any damage or stolen property.


This is a how to, that I came up. It's a very easy way on installing a double din. This tut is meant for all models in 00-04 Foci.

In order to get this installed you must have the Metra kit 95-5806 and the double din radio of your choice.

1. Start by removing your aftermarket radio and dash kit or factory radio.

2. Once removed start removing the 4 screws that hold the bezel in place. This can be found only after removing the radio. You will need a 7mm socket to remove the screws.

3. After the screws have been removed, pull out the ashtray and press down on the tab on the top and then gently slide out the entire tray. It helps if this is off the bezel, you'll understand during reinstall.

4. The bezel is snapped into place so gently with force pull off the bezel from the sides in order to remove the bezel.

5. Now start by disconnecting all the HVAC wires, cig lighter wires, and hazard switch wires.

6. Once you have the bezel free from the dash, start by removing all parts attached to the bezel(except the cig lighter) soo that your bezel will be naked.

As you can see in pictures, the radio will NOT slide in from the front without trimming of the top and bottom tabs of the bezel and rounding off the top corners more.

In this how to you will most likely not have to trim you bezel in order to install your radio. I know some of you like the clean look of an install and rather not scratch and mess up the face of the bezel in order for the radio to slide in from the front.

NOT all double dins are the same. Some are differently and will require you to trim the bezel a little. In order to check this, stand your radio face up and slide the bezel over the front. If the bezel does not slide more that 1/4 inch over then some trimming maybe be required. I went ahead and trimmed mine(I found out I didn't have to for my radio, i regret doing so haha). Here is an example of what needs to be trimmed:

7. Once the bezel is naked, it is time to attach the radio to the bezel. Follow by the steps I did in this video:
YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.

8. Once you have the radio attached to bezel, cut the the tab off that is circled in the picture below. Without cutting this tab, the bezel will not fit into the dash flush.

9. Once the tab is cut off, you can now put the bezel back together. Wire up the radio, connect the radio, HAVC, cig lighter and hazard switch. The radio will fit, but it will be snug. Slide the radio into place snugly, then snap the bezel into place. Then put the ashtray back in and your done!

10. Now sit back and enjoy your new double din radio.

<--EüRöFöCüS: 02 Twi Blu ZX5 FoFo Euroness SOLD!!!

New toy: TOYota FJ Cruiser 4x4

Last edited by Deaner; 05-18-2010 at 05:22 PM.
Deaner is offline  
    Reply With Quote

Bookmarks & Social Networks

Quick Reply

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:26 AM.

Copyright 2002-2014 All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat