sporadic's Turbo Duratec build thread

[brandon0133]

im useing a T25 turbo charger,,,looks just like the turbo in the FS kit,

[brandon0133]

also on the water ports...where do u tap into it? at the heater core hose connections off the firewall?

[sporadic]

Originally Posted by brandon0133

also on the water ports...where do u tap into it? at the heater core hose connections off the firewall?

Yes, I used the heater core lines:
http://www.focusfanatics.com/forum/s...8&postcount=52

[brandon0133]

and u just had the oil pan drilled out and welded in a nipple so to speak so the oil could drain back into it? i was told u can block off the coolant in and out ports and it wont hurt anything...any ideas?

[sporadic]

Originally Posted by brandon0133

and u just had the oil pan drilled out and welded in a nipple so to speak so the oil could drain back into it? i was told u can block off the coolant in and out ports and it wont hurt anything...any ideas?

Replied via PM to keep this thread on topic.

[oknvragain]

This post is going to be so much help. Thanks A lot. I'll be starting my Install on my 06 ZX3 in a month or so.

[sporadic]

Good luck on your build!

[brandon0133]

thanks sporadic,,helped alot,,,all the pictures to,,lol,,i ordered my Xcal2 from tom today...ball is rolling thanks to u

[brandon0133]

do u have to pass emissions in ure state? if so how did u get around it? is that a high flow cat u have and if so how did u mount it ? meaning where did u locate the o2 sensors and stuff?

[sporadic]

I do not have to pass emissions here, so the efficiency of my high flow cat isn't really measured.
My car does not use o2 sensors. It's tuned in open loop.
As for how that's done exactly I don't know. I'm no tuner.
The only o2 sensor in my entire exhaust is my wideband.