How to install foam speaker baffles in front doors - Ford Focus Forum, Ford Focus ST Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus Tech Discussions > Car Audio, SYNC, MyFord Touch & Electronics

Car Audio, SYNC, MyFord Touch & Electronics The Forum for the Ford Focus audiophiles. The place to chat about automobile sound systems, security systems, or show off your I.C.E.!
Sponsored By: GT Sound Control


Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-13-2007, 11:51 PM   #1
MisterJohnson
M0derator Monkey
 
MisterJohnson's Avatar
 
Join Date: Nov 2007
Fan#: 51724
Location: Sonora, CA
What I Drive: '04 ZX3 D23

Posts: 4,441
Points 62,373, Level 100
Points: 62,373, Level: 100 Points: 62,373, Level: 100 Points: 62,373, Level: 100
Level Up 0% Completed
Level up: 0% Level up: 0% Level up: 0%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 30 MisterJohnson Great Standing Member
Buy-Sell-Trade Rating: (18)
How to install foam speaker baffles in front doors

I installed new 6x8's in the front doors of my '04 ZX3, and I used the foam baffles from Crutchfield.com

There are two ways to do this, and I picked the hard way, I'll give you the easier way at the end.

There are other threads for removing door panels, so I'll leave that part out

For this version you'll need duck tape, longer screws, washers (if the screw heads aren't big enough), scissors, and your speaker's spacer (shown here)


IMPORTANT! Roll down the window before you start or you won't know how deep the baffles can go!

Here are the speaker, crossover, and baffle I used


Here you see how the baffles are too deep to fit the front door properly


Cut the top off the baffle so there's about 3/4" protruding


Use your scissors and make cuts in the top of the foam approximately 3/4" long about every 1" -1 1/2", then slide the spacer up the baffle and use strips of duck tape to fold the foam over the spacer


Finished it should look something like this


Now stick it in your door


And install the speaker with the longer screws and the washers.


I didn't want to punch a hole in the baffle, so I ran the wires out the front between the speaker and the baffle. The foam is thick enough that the wires don't create a gap.

For the easier way:
If you don't want/don't need to use the spacer, go ahead and do the cuts in the foam and then tape the flaps to the door panel. Then just install the speaker as normal.

If you're curious how I attached the crossover:
I made sure there would be enough space for it with the trim panel in place, then I checked behind the steel panel and made sure there was nothing in the way for drilling. Then I drilled holes and used zip-ties to secure the crossover. When drilling each hole you'll have to stop part way and remove the gorilla snot from the drill bit.

If you have manual roll up windows, here's a tip to make your life easier when re-installing the trim panel:
Put the clip back in the handle before you put the handle in place, then just snap the handle on. You don't have to squeeze the clip on through that tiny gap with the handle already on the door!


__________________
15.07 @ 93.49 Team Duratec #149

Last edited by MisterJohnson; 12-14-2007 at 08:00 PM.
MisterJohnson is offline  
    Reply With Quote
 

Bookmarks & Social Networks

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Timing Belt Info Spanky6935 General Technical Chat 13 09-30-2011 10:54 PM
Front strut tower bar install with aem cai SUCCES!!!!!!! breakdancein SVT Performance (2002-2004) 11 03-16-2004 10:38 PM
zx5/svt front vallence install? FOCUS03 MK1 Focus 4 01-24-2004 12:29 AM
?? about Euro front bumper install sooner-or-later-an-SVT MK1 Focus 1 09-18-2003 03:06 PM


All times are GMT -5. The time now is 07:58 AM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Terms of Use : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Acura TLX or Fiesta ST. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.