HOW-TO: Making an Ashtray Switch Panel (for neons, LEDs, and whatever else) - Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace

Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus First Generation > MK1 Interior Mods & Upgrades

MK1 Interior Mods & Upgrades The place to chat about performance gauges, shifter knobs, custom interior paint, car seats or any interior upgrades for the 2000-2007 Focus.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-30-2006, 10:16 PM   #1
Get Squashed
OrangeSVTguy's Avatar
Join Date: Mar 2006
Fan#: 33384
Location: Elyria, OH
What I Drive: '04 Comp. Orange SVT 3dr.

Posts: 5,381
Points 69,698, Level 100
Points: 69,698, Level: 100 Points: 69,698, Level: 100 Points: 69,698, Level: 100
Level Up 0% Completed
Level up: 0% Level up: 0% Level up: 0%
Forum Activity 1%
Activity: 1% Activity: 1% Activity: 1%
FF Reputation: 44 OrangeSVTguy Great Standing Member
Buy-Sell-Trade Rating: (16)
HOW-TO: Making an Ashtray Switch Panel (for neons, LEDs, and whatever else)

this is my first "HOW TO" so i hope i do this right...

This how to make an Ashtray Switch Panel to control your Neons, LEDs, Fog Lights, and whatever else that could be controlled with a switch. This mounts in your 00-04 factory pull out ashtray. Only minor modifications will be required to install this switch panel and are completly reversable.

I am a sheet metal worker so I have all the tools required to make this job easier and also have access to the metal very easlly. I also linked pictures of the tools/materials below to keep this page as small as possible for the 56k users so be sure to click them if you don't know what they are.

What you will need:
26 gauge sheet metal 6-3/4" x 4-3/4" (find at home depot etc...)
4 - On/Off switches (can be lighted)
12 ga. wire
14 ga. wire
spray paint (color of your choice)
hot glue gun
sharpie permanent marker (or scratch awl)
inline fuse holder or add-a-circuit

Reamer Drill Bit (Picture)
tin snips (rights and straights)
tongs (folding bar)
Pics of Tools (tin snips, tongs, scratch awl)

to disassemble the ashtray, pop off the top spring plate. next turn it over and take a small screwdriver and pop out the small block tabs through the little square holes to remove the block in the front.

first take your piece of sheet metal, measure and draw lines as follows
you'll notice how one side is shorter then the other, this is because one side of the ashtray is taller then the other. that way the tray should slide in easily without the switches catching onto anything.

cut out using the straight tin snips

fold in a 1/2" all the way around using your tongs

next fold the remaining 3 sides in all about 85* angle. it will seat in the ashtray a whole lot nicer and easier.

measure your switches and then center them up on your cover.
(the mounting holes for mine were 13/16" so I measured 5/8" from the sides to center of hole and then 3/4" from the front to center of hole. then measure 1-3/8" center to center of holes for the front to back one.) using the reamer drill bit, drill out the holes for your switches

next you can spray paint the cover the color of your choice and then let dry for a few hours.

then snap switches into the holes. using a hot glue gun, glue the switches from underneath to keep them from turning.

here are some of the ones i made for other users on

I'll come back and edit this so I can show you how to wire it up.

SVT Squad #227 || Build # 1329 of 1978 || FF ROTM Oct. 2006

Last edited by OrangeSVTguy; 06-10-2006 at 11:11 AM.
OrangeSVTguy is offline  
    Reply With Quote

Bookmarks & Social Networks

Quick Reply

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:21 AM.

Copyright 2002-2014 All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat