Cleaning the EGR tube - Ford Focus Forum, Ford Focus ST Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus Tech Discussions > General Technical Chat

General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Reply
 
Thread Tools Display Modes
Old 03-05-2013, 10:08 AM   #1
Andrews-bad-SE
Focus Enthusiast
 
Join Date: Jun 2012
Fan#: 100389
Location: O'fallon, MO
What I Drive: 2003 Arizona Beige SE 4dr Zetec/ATX

Posts: 182
FF Reputation: 3 Andrews-bad-SE Good Standing Member
Buy-Sell-Trade Rating: (2)
Cleaning the EGR tube

I'm about to embark on the magical journey of cleaning out my EGR tube, the intake side of the valve in particular (as I seem to have neglected that out of my own stupidity.)

I'm going to remove the valve and tube, and clean everything up with a pipe cleaner and some TB spray but I was just wondering if there are any tried and true methods that anyone onhere seems to favor.


Andrews-bad-SE is offline  
    Reply With Quote
Old 03-05-2013, 10:53 AM   #2
Magus2727
Focus Fanatic
 
Magus2727's Avatar
 
Join Date: Feb 2009
Fan#: 62897
Location: Salt Lake City, UT
What I Drive: 2001 Malibu Blue ZX3

Posts: 4,005
FF Reputation: 9 Magus2727 Good Standing Member
Buy-Sell-Trade Rating: (2)
Time... let the tube soak. make sure you use a small enough pipe cleaner to go through the constrictor otherwise you may push gunk into it and end up clogging it.

have compressed air so you can force air through.

when installing use appropriate anti-seize so future removal is easy that nut becomes difficult to remove with the heat and thermal cycles it sees.

The tube should be fairly clean given how much actually is able to flow back into the intake.
__________________
2001 ZX3 2.0L Zetec-
Hatch Nation #42

Going through Rebuild See "The TICK Build Thread" for details (http://www.focusfanatics.com/forum/showthread.php?t=289168&referrerid=62897)
Magus2727 is offline  
    Reply With Quote
Old 03-05-2013, 01:58 PM   #3
zpellicone
Focus Enthusiast
 
Join Date: Oct 2012
Fan#: 105007
Location: Charlotte, NC
What I Drive: 2001 Pitch Black ZTS

Posts: 56
FF Reputation: 1 zpellicone Good Standing Member
Buy-Sell-Trade Rating: (0)
Im curious if I should do this. What is the outcome when you do this? Smoother idle, better gas mileage?
zpellicone is offline  
    Reply With Quote
Old 03-05-2013, 03:19 PM   #4
Magus2727
Focus Fanatic
 
Magus2727's Avatar
 
Join Date: Feb 2009
Fan#: 62897
Location: Salt Lake City, UT
What I Drive: 2001 Malibu Blue ZX3

Posts: 4,005
FF Reputation: 9 Magus2727 Good Standing Member
Buy-Sell-Trade Rating: (2)
no real reason to worry about it. It is not a "dirty" part. You would not crack open your exhaust system to clean them out. I would only clean it if you had it out or replacing it for some other reason.
__________________
2001 ZX3 2.0L Zetec-
Hatch Nation #42

Going through Rebuild See "The TICK Build Thread" for details (http://www.focusfanatics.com/forum/showthread.php?t=289168&referrerid=62897)
Magus2727 is offline  
    Reply With Quote
Old 03-06-2013, 12:27 AM   #5
amc49
Focus Fanatic
 
Join Date: Mar 2012
Fan#: 96610
Location: Fort Worth, TX
What I Drive: 00 wagon, 02 sedan both zetec atx

Posts: 4,801
FF Reputation: 23 amc49 Great Standing Member
Buy-Sell-Trade Rating: (0)
Absolutely worthless to clean it until clogged enough the passage gets smaller than the restriction hole in there...................
amc49 is offline  
    Reply With Quote
Old 03-06-2013, 08:22 AM   #6
Andrews-bad-SE
Focus Enthusiast
 
Join Date: Jun 2012
Fan#: 100389
Location: O'fallon, MO
What I Drive: 2003 Arizona Beige SE 4dr Zetec/ATX

Posts: 182
FF Reputation: 3 Andrews-bad-SE Good Standing Member
Buy-Sell-Trade Rating: (2)
Mine's just throwing the P0401 still and I've cleaned/replaced everything... but I forgot to clean the tube that goes into the intake from the valve (Zetec 2.0 engine btw). I'm just afraid that I might accidentally push some crap into the intake and the engine would suck it all up.
Andrews-bad-SE is offline  
    Reply With Quote
Old 03-06-2013, 10:12 AM   #7
Magus2727
Focus Fanatic
 
Magus2727's Avatar
 
Join Date: Feb 2009
Fan#: 62897
Location: Salt Lake City, UT
What I Drive: 2001 Malibu Blue ZX3

Posts: 4,005
FF Reputation: 9 Magus2727 Good Standing Member
Buy-Sell-Trade Rating: (2)
You have replaced the DPFE with a Ford one? Aftermarket ones are not so great at this... Have you replaced the EGR valve or just try to "clean" it?

P0401 - EGR Flow Insufficient Detected
The EGR system is monitored during steady state driving conditions while the EGR is commanded on. The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum.
Vacuum supply
EGR valve stuck closed
EGR valve leaks vacuum
EGR flow path restricted
EGRVR circuit shorted to PWR
VREF open to D.P.F. EGR sensor
D.P.F. EGR sensor downstream hose off or plugged
EGRVR circuit open to PCM
VPWR open to EGRVR solenoid
D.P.F. EGR sensor hoses both off
D.P.F. EGR sensor hoses reversed
Damaged EGR orifice tube
Damaged EGRVR solenoid
Damaged PCM
Perform KOER self-test and look for DTC P1408 as an indication of a hard fault. If P1408 is not present, look for contamination, restrictions, leaks, and intermittents.



Define "Crap" If you have crap that go in there then you have larger issues then just EGR codes. The EGR is a quasi closed system. It only routes a small portion of pre CAT exhaust into the intake after the TB. Any "Crap" would also be coating your catalytic converter and plugging the honeycomb or building up over time a thicker and thicker layer on the exhaust manifold.
__________________
2001 ZX3 2.0L Zetec-
Hatch Nation #42

Going through Rebuild See "The TICK Build Thread" for details (http://www.focusfanatics.com/forum/showthread.php?t=289168&referrerid=62897)
Magus2727 is offline  
    Reply With Quote
Old 03-10-2013, 09:11 PM   #8
amc49
Focus Fanatic
 
Join Date: Mar 2012
Fan#: 96610
Location: Fort Worth, TX
What I Drive: 00 wagon, 02 sedan both zetec atx

Posts: 4,801
FF Reputation: 23 amc49 Great Standing Member
Buy-Sell-Trade Rating: (0)
With automatic mixture control EGR parts stay quite a bit cleaner than they used to. I remember the days when you could cake up half inch diameter pipes solid as a rock with carbon.

Probably DPFE sensor, especially if the very short stub hosed one. I had to make up a workaround on mine when water kept getting into sensor to fault it.
amc49 is offline  
    Reply With Quote
Old 03-10-2013, 09:33 PM   #9
don627
Focus Enthusiast
 
Join Date: Jun 2008
Fan#: 56863
Location: dayton, ohio
What I Drive: 2007 infra-red zx3

Posts: 394
FF Reputation: 1 don627 Good Standing Member
Buy-Sell-Trade Rating: (0)
Check for VAC leaks especially the one that attach to the dpfe sensor.
don627 is offline  
    Reply With Quote
Old 03-10-2013, 10:42 PM   #10
Andrews-bad-SE
Focus Enthusiast
 
Join Date: Jun 2012
Fan#: 100389
Location: O'fallon, MO
What I Drive: 2003 Arizona Beige SE 4dr Zetec/ATX

Posts: 182
FF Reputation: 3 Andrews-bad-SE Good Standing Member
Buy-Sell-Trade Rating: (2)
I'll look into the DPFE sensor then. That seems to be a tricky little bugger. Thanks for the help!
Andrews-bad-SE is offline  
    Reply With Quote
Reply

Bookmarks & Social Networks
-->
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:16 AM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Terms of Use : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Acura TLX or Fiesta ST. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.