oil feed fitting

[J0EC00L]

I am going to be installing a Top Speed Turbo kit that I have on my Zetec engine in the next couple months. I have read that a good place to get my oil feed from is below the coil on the head. Does anyone know what size thread fitting that I need to tap into that spot? Or if anyone has a better suggestion for where to get my oil feed from?

Thanks,
Joe

[Sponsor]

[ZXthrizzle05]

I used an 1/8 npt fitting ad connected my -4an feed line right into it. heres a picture for ya JOE

[J0EC00L]

Thanks a bunch.

Do you still have your EGR hooked up? I see it in the pic.

[ZXthrizzle05]

yea unfortunately. been to lazy to take it off. but it is saudered shut. im looking to buy a built head and ill just delete the egr once I take it off. be easier for access

[J0EC00L]

I see.

I have another question.

I am putting the top speed kit on my stock zetec(by stock I mean it is stock head and bottom end) and I put the lightest spring in my wastgate, a little less than 5psi. Eventually I will be swapping out the engine with a fully built one from Focus Power.
I guess your supposed to use 1 step colder per 50HP. So with my engine the way it is now putting on the 5psi turbo should I go with 1 or 2 step colder plug??

Thanks

[koke'sfocus]

U will be fine with 1 step colder just get the auto lite ar103s



[/B]

Originally Posted by J0EC00L

I see.

I have another question.

I am putting the top speed kit on my stock zetec(by stock I mean it is stock head and bottom end) and I put the lightest spring in my wastgate, a little less than 5psi. Eventually I will be swapping out the engine with a fully built one from Focus Power.
I guess your supposed to use 1 step colder per 50HP. So with my engine the way it is now putting on the 5psi turbo should I go with 1 or 2 step colder plug??

Thanks

[sleepyboy]

AR103's are for a duratec he has a Zetec.


You would want to use these plugs right HERE.

[Mother Focus]

Originally Posted by sleepyboy

AR103's are for a duratec he has a Zetec.


You would want to use these plugs right HERE.

Agree, I run the same gapped to .028

[ZXthrizzle05]

yep and when you go higher in hp you can get the denso iridium 4 step colder plugs, remember with boost you have to change them more often

[scopymatt]

yeah, good info to me, U will be fine with 1 step colder just get the auto lite ar103s ,thank you