HELP - Any 05-07 Focus owner w cruise? - Ford Focus Forum, Ford Focus ST Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus First Generation > MK1 Focus

MK1 Focus The place to chat about general questions, window tinting, exterior body, interior and lighting upgrades for the first generation 2000-2007 Focus.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Reply
 
Thread Tools Display Modes
Old 03-24-2012, 02:19 PM   #1
Lscman
Focus Enthusiast
 
Join Date: Feb 2012
Fan#: 95211
Location: northeast, PA
What I Drive: 2007 ZX3

Posts: 305
FF Reputation: 9 Lscman Good Standing Member
Buy-Sell-Trade Rating: (1)
HELP - Any 05-07 Focus owner w cruise?

Can you please open the hood of your '05-'07 focus with factory cruise and tell me where the cruise servo control wiring enters the main harness? It could be up near the headlight, inside drivers fender, under the fusebox, near the strut or engine or down below near the tranny.

I bought a used cruise module and they provided the connector with a pigtail of wire about a foot long. I'm not sure if this car has a cruise connector and wire buried somewhere because the dash harness is equipped (wired cruise-ready).

PS: Your cruise servo module is an aluminum box with cable to the throttle body, mounted in front of the left strut on a bracket between the drivers side fender and the battery.

sincere thanks


Lscman is offline  
    Reply With Quote
Old 03-24-2012, 09:53 PM   #2
mainest
Focus Addict
 
mainest's Avatar
 
Join Date: Oct 2008
Fan#: 60163
Location: DownEast, ME
What I Drive: '04 Red Euro SVT

Posts: 1,112
FF Reputation: 7 mainest Good Standing Member
Buy-Sell-Trade Rating: (12)
My '05 ST has cruise. There is a "conduit" from the cruise servo to the large harness to the left of the battery, to the rear of the servo, and to the right of the driver side fender. There is a ground to chassis from the large harness, and a "conduit" to the battery (negative) terminal. The "conduit" from the cruise servo enters that large conduit at the same point where the conduit to the battery negative terminal exits that large harness. I will send you photos if you PM me your e-mail.
mainest is offline  
    Reply With Quote
Old 03-25-2012, 08:59 AM   #3
Lscman
Focus Enthusiast
 
Join Date: Feb 2012
Fan#: 95211
Location: northeast, PA
What I Drive: 2007 ZX3

Posts: 305
FF Reputation: 9 Lscman Good Standing Member
Buy-Sell-Trade Rating: (1)
Quote:
Originally Posted by mainest View Post
My '05 ST has cruise. There is a "conduit" from the cruise servo to the large harness to the left of the battery, to the rear of the servo, and to the right of the driver side fender. There is a ground to chassis from the large harness, and a "conduit" to the battery (negative) terminal. The "conduit" from the cruise servo enters that large conduit at the same point where the conduit to the battery negative terminal exits that large harness. I will send you photos if you PM me your e-mail.
Wow, that's really helpful. Your good reputation is deserved and growing!! I will send you a PM for the pic. This could easily save me 1/2 day of work and slicing OEM taped conduit to expose wiring. I'll let everyone know if '05-'07 Focus with no cruise option are wired in the engine compartment.
Lscman is offline  
    Reply With Quote
Old 12-28-2012, 09:31 PM   #4
Lscman
Focus Enthusiast
 
Join Date: Feb 2012
Fan#: 95211
Location: northeast, PA
What I Drive: 2007 ZX3

Posts: 305
FF Reputation: 9 Lscman Good Standing Member
Buy-Sell-Trade Rating: (1)
dupl post
Lscman is offline  
    Reply With Quote
Old 12-28-2012, 09:33 PM   #5
Lscman
Focus Enthusiast
 
Join Date: Feb 2012
Fan#: 95211
Location: northeast, PA
What I Drive: 2007 ZX3

Posts: 305
FF Reputation: 9 Lscman Good Standing Member
Buy-Sell-Trade Rating: (1)
The '07 Focus S without cruise is not wired in the engine compartment. This would likely apply to '06 and may apply to '05 cars. That harness going from the servo to the dash area must be fabricated. All Duratec cars have the same setup including pre-'05 cars with optional pzev. Wiring for duratec cruise is very similar to zetec and described in other threads.
Lscman is offline  
    Reply With Quote
Reply

Bookmarks & Social Networks
-->
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:04 AM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Terms of Use : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Acura TLX or Fiesta ST. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.