|
||||||||
|
Auto Cross, Drag Racing, Car Show, Awards & Prizes - Register Now! |
||||||||
|
|||||||
ZETEC Performance (2000-2004) The place to chat about any 2.0L Zetec engine performance, tuning and exhaust related upgrades.
|
![]() |
![]() |
|
|
|
Thread Tools | Display Modes |
|
|
|
|
#1 | ||||
|
Focus Rookie
|
Hi everyone! I'm a middle-aged professor experiencing his first car with mods. I just had a Volant CAI and the Focus Central 65mm throttle body installed at my Ford dealer. Great throttle response
|
||||
|
|
|
|
|
Remove Advertisements |
|
Focus Fanatic
Fan#: 1
|
|
|
|
#2 | ||||
|
Focus Fanatic
|
well does it sound like there is an air leak? does it go ssss when u first get goin? it may be just you too... just keep drivin till u get used to it.
__________________
Quote:
|
||||
|
|
|
|
|
#3 | ||||
|
Focus Enthusiast
|
If you do hear a hiss, make sure it's not coming from your cai. They make a hissing noise when you give it a little gas.
__________________
"Don‘t C-walk unless you know how!" Mods: |
||||
|
|
|
|
|
#5 | ||||
|
FF #1 Most Wanted
|
The sticky throttle got me too.
I messed with the throttle cable and stuff then someone told me to turn the idle screw a little bit and the sticky throttle was resolved. The throttle butterfly/plate inside gets wedged or something at the idle postion. When the throttle was sticky, I would buck off the line sometimes because I had to apply enough pressure on the gas/throttle to pop/unstick the throttle. When I would press on the gas, it wouldn't go then I give a little more pressure and the throttle unsticks. It was also intermittent. Would only do it when the temp outside was colde. Well, I turned my idle screw about 1/4 turn and my throttle hasn't been sticky since.
__________________
Just reading..... |
||||
|
|
|
|
|
#6 | ||||
|
Focus Addict
|
The throttle response is amazing ( i mean tap a little too hard and your bucking like a horse)
and takes time to relearn. I know my car SOUNDS like it will stall easier when in fact it wont. Check hoses tho and make sure the breather is connected to the volant and make sure nothing is loose already |
||||
|
|
|
|
| Bookmarks & Social Networks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| $0 Thunder Throttle - Official DIY & Details | tb1999 | DURATEC Performance (2003-2011) | 142 | 10-30-2011 01:59 PM |
| Throttle body & IAC code problem | carguychris | General Technical Chat | 0 | 10-13-2008 09:02 PM |
| Another 65MM Throttle Body Question | Strider | ZETEC Performance (2000-2004) | 9 | 05-28-2007 10:10 AM |
| New throttle body and Volant. | the_poet677 | Fanatics: SoCal | 21 | 07-12-2006 12:05 AM |
| Throttle Body Install Q's | Lil_RedZX3 | ZETEC Performance (2000-2004) | 1 | 09-14-2003 10:41 PM |
|
||||